Philips HD7820 Owner's Manual page 17

Problem
Type HD7826/HD7824 only:
the 2-cup button qq/
cannot be operated.
Water leaks from the coffee
machine.
The coffee spout cannot be
taken out of the machine.
The lid cannot be opened.
The coffee machine
produces less coffee than
before.
Solution
there is enough water in the water reservoir (i.e. above the q MIN level
if you want to brew 1 cup);
the ambient temperature is not lower than 50cF / 10cC. If it is, the
machine will not function properly.
Make sure that there is enough water in the water reservoir for brewing
w
2 cups of coffee. If the light ring around the 2-cup button qq/
there is not enough water in the water reservoir for brewing 2 cups.
Make sure that:
the lid is properly closed (the lever must be properly locked);
the water reservoir has not been filled beyond the MAX level;
the sieve in the centre of the pod holder is not clogged. If it is, unclog the
sieve by holding the pod holder under a running tap. If necessary, you can
use a soft dish brush or a pin to unclog the sieve;
the coffee pod has been put properly in the centre of the pod holder;
the sealing ring has not got stuck under the edge of the water distribution
disc..
the water drops on the worktop are not the result of placing or
removing the water reservoir or removing used coffee pods.
you do not remove the water reservoir when the coffee machine is
heating up. This may cause water that normally ends up in the water
reservoir to leak out of the machine.
In all other cases, contact the Philips Norelco Service Location.
The coffee spout can only be taken out after the coffee collector has
been removed.
A vacuum may have temporarily formed under the lid.
Switch the machine off. Pull the lever up as far as it will go and wait
24 hours before opening the lid. You may need to use quite some force.
Make sure that the sieve in the centre of the pod holder is not clogged.
If it is, unclog the sieve by holding the pod holder under a running tap. If
necessary, you can use a soft dish brush or a pin to unclog the sieve.
If problems continue to occur, contact the Philips Norelco Service
Location.
Perhaps the sieve in the centre of the pod holder is clogged. If this is the
case, unclog the sieve by rinsing the pod holder under a running tap. Use
a soft dish brush to clean the sieve, if necessary.
Descale the machine (see chapter 'Descaling').
17
w
is out,