Configuration - Cisco SCH-7IN-TS-B/W Reference Manual

Configuration

If the touchscreen will connect to the wireless network, you must configure the Wi-Fi settings on the
device. Use Composer Pro to add the touchscreen driver to your project and configure the device
features.
Refer to the following for more information:
•
•
Configure for Wireless
(Wi-Fi only) Complete the following procedure to connect to a WAP using the touchscreen.
Procedure
After initialization, press and hold the large White 4 in the center of the touchscreen to enter the
Step 1
configuration screen.
Step 2 Press the Network button on the touchscreen's configuration page. The network configuration screen
displays.
Step 3 Under Wireless, select Enable. If you don't see the network you want, select Other.
Step 4 At Network Name, select to add the SSID or wireless network when the keyboard appears. Select Done.
At Security, select None, WEP 64, WEP 128, WPA, or WPA2.
Step 5
At Password, type the password on the keyboard that appears. Press Done.
Step 6
Select Connect. Notice that the IP settings change. The IP address is set to DHCP by default.
Step 7
(Optional) If you need to set a static IP address instead, complete the following steps:
Step 8
a.
b.
c.
Press OK to return to the Network page. You can now connect to a Director (Cisco Controller) on the
Step 9
network.
Press OK.
Step 10
OL-27263-01
Configure for Wireless, page 15
Configure in Composer Pro, page 16
On the Network page, press Static.
Select each box one at a time and type the address: IP Address, Subnet Mask, Default Gateway,
Preferred DNS, and Alternate DNS.
When the keyboard appears, type the address, and then press Done.
Cisco Smart+Connected 7" In-wall Display Reference Guide
Configuration
15