Cisco Unified Communications Manager Phone
Setup
•
•
•
•
•
•
•
Set Up Cisco IP Phone
If autoregistration is not enabled and the phone does not exist in the Cisco Unified Communications Manager
database, you must configure the Cisco IP Phone in Cisco Unified Communications Manager Administration
manually. Some tasks in this procedure are optional, depending on your system and user needs.
For more information on any of the steps, see the documentation for your particular Cisco Unified
Communications Manager release.
Perform the configuration steps in the following procedure using Cisco Unified Communications Manager
Administration.
Gather the following information about the phone:
• Phone model
• MAC address: see
• Physical location of the phone
• Name or user ID of phone user
Determine Phone MAC Address, on page 47
Cisco IP Phone 7800 Series Administration Guide for Cisco Unified Communications Manager
5
C H A P T E R
43