Table of Contents
Advertisement
Microphone Supply
X-GOLD™213 has a single ended power-supply concept for electret microphones:
For both modes a minimal load capacitance of t.b.d. nF is necessary to guarantee stable operation of the
buffer.
The maximal load capacitance must not exceed t.b.d. nF.
2 microphone supplies VMIC and VUMIC are available. The supply VUMIC has a ultra-low-power mode, where
the current consumption is minimum, whilst at the same time the noise performance is reduced.
For this purpose the VUMIC is directly supplied out of the VMIC regulator, the Mic-Buffer can be switched off
and only the quiescent current of the VMIC regulator is present. This mode can be used to supply a headset
and allow accessory detection with highly reduced current consumption For normal operation the supply
can be switched to normal operation mode with improved noise performance. In case of an digital
microphone VMIC can be used for supplying this microphone.
Figure 3.12.5 Typical Microphone Supply Generation (alternative)
Copyright © 2010 LG Electronics. Inc. All right reserved.
Only for training and service purposes
- 57 -
3. TECHNICAL BRIEF
3. TECHNICAL BRIEF
LGE Internal Use Only
Advertisement
Table of Contents
