Philips 5231 series User Manual page 45

Reinstall channels
You can always start an channel update yourself.
To start a channel update manually...
1. Press  , select Satellite installation and
press OK.
2. Enter your PIN code if necessary.
3. Select Search for satellite and press OK.
4. Select Re-install channels, and press OK.
5. Select Reinstall, and press OK.
6. Select one item you need to re-install.
7. Select Start and press OK to update channels.
This can take a few minutes.
5. Press  BACK to close the menu.
Add a satellite
You can add an additional satellite to your current
satellite installation. The installed satellites and their
channels stay untouched. However, some satellite
operators do not allow adding a satellite.
The additional satellite should be seen as an extra, it
is not your main satellite subscription or not the main
satellite of which you use its channel package.
Typically, you would add a 4th satellite when you
have 3 satellites already installed. If you have 4
satellites installed, you might consider removing one
first to be able to add a new satellite.
Settings
If you currently have only 1 or 2 satellites installed, the
current installation settings might not allow adding an
extra satellite. If you need to change the installation
settings, you must redo the complete satellite
installation. You cannot use Add satellite if a change
of settings is needed.
To add a satellite . . .
1. Press  , select Satellite installation and
press OK. Enter your PIN code if necessary.
2. Select Search for satellite and press OK.
3. Select Add satellite and press OK. The current
satellites are shown.
4. Select Add and press OK. The TV will search for
new satellites.
5. If the TV has found one or more satellites,
select Install and press OK. The TV installs the
channels of the found satellites.
6. To store the channels and radio stations,
select Finish and press OK.
Remove a satellite
You can remove one or more satellites from your
current satellite installation. You remove the satellite
and its channels. However, some satellite operators
do not allow removing a satellite.
To remove satellites . . .
1. Press  , select Satellite installation and
press OK. Enter your PIN code if necessary.
2. Select Search for satellite and press OK.
3. Select Remove satellite and press OK. The
current satellites are shown.
4. Use the arrows keys to select the satellite you
want to remove.
5. Press OK to mark a satellite to remove.
Press OK again to unmark.
6. Select Remove, press OK and confirm. The
satellites are removed.
7. Select Exit and press OK to close Remove
satellite.
Manual installation
Manual Installation is intended for expert users.
You can use Manual Installation to quickly add new
channels from a satellite transponder. You need to
know the frequency and polarization of the
transponder. The TV will install all channels of that
transponder. If the transponder was installed before,
all its channels - the former and the new ones - are
moved to the end of the channel list All.
You cannot use Manual installation if you need to
change the number of satellites. If this is needed, you
have to do a complete installation with Install
Satellites.
To install a transponder...
1. Press  , select Satellite installation and
press OK. Enter your PIN code if necessary.
2. Select Search for satellite and press OK.
3. Select Channel installation > Manual
installation and press OK.
4. If you have more than 1 satellite installed,
select LNB for which you want to add channels.
5. Set the Polarisation you need. If you set
the Symbol rate Mode to manual, you can enter
the symbol rate in Symbol rate manually.
6. Press the arrows  (up) or  (down) to adjust
the frequency, and select Done.
7. Select Search and press OK. The signal strenght
is shown on screen.
8. If you want to store the channels of a new
transponder, select Store and press OK.
Satellite installation settings
The satellite installation settings are preset according
your country. These settings determine how the TV
searches and installs satellites and its channels. You
can always change these settings.
To change the satellite installation settings...
1. Start the satellite installation.
45