Jenn-Air H325B Manual

Internal blowers
Table of Contents

Advertisement

Available languages

Available languages

INTERNAL BLOWERS
(for use with JXT-B Series Range Hoods)
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR
INJURY TO PERSON(S) OBSERVE THE FOLLOWING:
1. Use this unit only in the manner intended by the manufac-
turer. If you have questions, contact the manufacturer at the
address or telephone number listed in the warranty.
2. Before servicing or cleaning unit, switch power off at service
panel and lock service disconnecting means to prevent power
from being switched on accidentally. When the service dis-
connecting means cannot be locked, securely fasten a promi-
nent warning device, such as a tag, to the service panel.
3. Installation work and electrical wiring must be done by quali-
fied personnel in accordance with all applicable codes and
standards, including fire-rated construction codes and stan-
dards.
4. Sufficient air is needed for proper combustion and exhausting
of gases through the flue (chimney) of fuel burning equipment
to prevent backdrafting.Follow the heating equipment
manufacturer's guidelines and safety standards such as those
published by the National Fire Protection Association (NFPA),
and the American Society for Heating, Refrigeration and Air
Conditioning Engineers (ASHRAE), and the local code au-
thorities.
5. When cutting or drilling into wall or ceiling, do not damage
electrical wiring and other hidden utilities.
6. Ducted fans must always be vented to the outdoors.
7. Do not use this range hood with any additional solid-state
speed control device.
8. To reduce the risk of fire, use only steel ductwork.
9. This unit must be grounded.
TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:
a) Never leave surface units unattended at high settings.
Boilovers cause smoking and greasy spillovers that may ig-
nite. Heat oils slowly on low or medium settings.
b) Always turn hood ON when cooking at high heat or when cook-
ing flaming foods.
c) Clean ventilating fans frequently. Grease should not be al-
lowed to accumulate on fan or filter.
d) Use proper pan size. Always use cookware appropriate for
the size of the surface element.
MODELS H325B & H326B
NOTE: These blowers are compatible with older
"JXT-A Series" Range Hoods. Refer to the
installation instructions included with the hood.
WARNING
TO REDUCE THE RISK OF INJURY TO PERSON(S) IN THE
EVENT OF A RANGE TOP GREASE FIRE,OBSERVE THE
FOLLOWING*:
1. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or
metal tray, then turn off the burner. BE CAREFUL TO PRE-
VENT BURNS. IF THE FLAMES DO NOT GO OUT IMMEDI-
ATELY, EVACUATE AND CALL THE FIRE DEPARTMENT.
2. NEVER PICK UP A FLAMING PAN – You may be burned.
3. DO NOT USE WATER, including wet dishcloths or towels –
This could cause a violent steam explosion.
4. Use an extinguisher ONLY if:
A. You know you have a Class ABC extinguisher and you know
how to operate it.
B. The fire is small and contained in the area where it started.
C. The fire department has been called.
D. You can fight the fire with your back to an exit.
* Based on "Kitchen Fire Safety Tips" published by NFPA.
CAUTION
1. For general ventilating use only. Do not use to exhaust haz-
ardous or explosive materials and vapors.
2. To avoid motor bearing damage and noisy and/or unbalanced
impellers, keep drywall spray, construction dust, etc. off power
unit.
3. This blower has a thermal overload which will automatically
shut off the motor if it becomes overheated.The motor will
restart when it cools down.If the motor continues to shut off
and restart, have the hood serviced.
4. For best capture of cooking impurities, the bottom of the hood
should be a minimum of 24" and a maximum of 30" above the
cooking surface.
5. Please read specification label on product for further informa-
tion and requirements.
6. To reduce the risk of fire and to properly exhaust air on a
ducted installation, be sure to duct air outside – Do not ex-
haust air into spaces within walls or ceiling or into attics, crawl
spaces, or garage.
7. This product is equipped with a thermostat which may start
blower automatically. To reduce the risk of injury and to pre-
vent power from being switched on accidentally, switch power
off at service panel and lock or tag service panel.
8. The H325B & H326B Blowers must be installed with JXT-B
Series Range Hoods only. Other Range Hoods cannot be sub-
stituted. (Range Hood sold separately.)
Save this manual for Electrical
Inspector and Homeowner to use.
1
!
INSTALLER:

Advertisement

Table of Contents
loading

Summary of Contents for Jenn-Air H325B

  • Page 1 8. The H325B & H326B Blowers must be installed with JXT-B Series Range Hoods only. Other Range Hoods cannot be sub- stituted.
  • Page 2 / right front / rear JXA-B SERIES SOFFIT CHIMNEY (Required only for soffit-less or direct horiz. discharge installations) MODEL H325B BLOWER / ROUGH-IN KIT Choose 1 of 2 MODEL H326-B (600 cfm Interior JXT-B Blower Systems BLOWER / Blower &...
  • Page 3: Installation

    INSTALLATION INSTALLATION Model H325B Single-Wheel Blower Model H326B Dual-Wheel Blower VERTICAL DISCHARGE VERTICAL DISCHARGE ROUGH-IN PLATE POWER CORD ROUGH-IN PLATE POWER CORD ROUGH-IN PLATE ROUGH-IN PLATE (Locate at (Locate at right side of hood) SLOT right side of hood) MOUNTING...
  • Page 4: Service Parts

    SERVICE PARTS Model H325B Single-Wheel Blower & Rough-in Kit PART NUMBER DESCRIPTION QTY. 97010792 Damper Assembly 99170245 Screw, #8-18 x 3/8* 97014276 Rough-in Plate Weldment 99100387 Polyfoam 99380605 Barrel Nut 99150471 Screw, #10-32 x ½ Hex Washer Head 98003370 Outlet Box Cover...
  • Page 5 SERVICE PARTS Model H326B Dual-Wheel Blower & Rough-in Kit PART NUMBER DESCRIPTION QTY. 97014160 Rough-in Plate Weldment 99100387 Polyfoam 99380605 Barrel Nut 99150471 Screw, #10-32 x ½ Hex Washer Hd. * 98003370 Outlet Box Cover 99100382 Strain Relief 99440033 Power Cord 99170245 Screw, #8-18 x 3/8 * ‡...
  • Page 6 JENN-AIR WARRANTY Congratulations on your purchase of a Jenn-Air appliance. We wish to express our confidence in the product by advising you of our warranty. All Jenn-Air appliances carry a minimum warranty of 1st year full warranty parts and labor, plus a 2nd year limited warranty parts only.
  • Page 7 étiquette de manière à éviter que le courant ne soit rétabli par accident. 8. Les ventilateurs H325B et H326B doivent être installés uniquement avec les hottes de cuisine de série JXT-B. Aucune autre hotte ne peut être substituée. (Hotte vendue séparément.) INSTALLATEUR : Conservez ce manuel pour l’inspec-...
  • Page 8 10”/25.4cm (Nécessaire horizontale/ 25.4cm- arrière seulement pour les verticale droite installations sans soffite ou avec échappement horizontal direct) MODÈLE H325B VENTILATEUR/ PLAQUE- Choisissez un des VENTILATEUR MODÈLE H326B deux systèmes de SÉRIE JXT-B (ventilateur VENTILATEUR/PLAQUE- ventilation HOTTE intérieur 600 pcm...
  • Page 9 INSTALLATION INSTALLATION Ventilateur à roue simple modèle H325B Ventilateur à deux roues modèle H326B PLAQUE DE JONCTION SORTIE VERTICALE SORTIE VERTICALE PLAQUE DE JONCTION ET CORDON ÉLECTRIQUE ET CORDON ÉLECTRIQUE (Placez sur le bon côté du hotte.) PLAQUE DE JONCTION GOUJONS DE MONTAGE (Placez sur le bon côté...
  • Page 10: Pièces De Rechange

    PIÈCES DE RECHANGE Modèle H325B Ventilateur à roue simple et Plaque de jonction REPÈRE N° PIÈCE DESCRIPTION QTÉ 97010792 Ensemble de clapet 99170245 Vis n° 8-18 x 3/8* 97014276 Plaque de jonction soudée 99100387 Mousse de polyuréthane 99380605 Écrou à portée cylindrique 99150471 Vis hexagonale*, n°...
  • Page 11 PIÈCES DE RECHANGE Modèle H326B Ventilateur à deux roues et Plaque de jonction REPÈRE N° PIÈCE DESCRIPTION QTÉ 97014160 Plaque de jonction soudée 99100387 Mousse de polyuréthane 99380605 Écrou à portée cylindrique 99150471 Vis hexagonale*, n° 10-32 x 1/2 * 98003370 Couvercle de boîte de connexion 99100382...
  • Page 12 Conformément à la garantie complète, les réparations doivent être exécutées par un technicien Jenn-Air agréé. Pour faire réparer votre appareil, contactez l’établissement où vous avez affectué votre achat, un technicien agréé ou le service à la clientèle Jenn-Air, a/s Service à la clientèle Maytag, B.P.
  • Page 13 8. Los ventiladores modelos H325B y H326B se deben instalar PARA LA PERSONA QUE REALIZA LA INSTALACIÓN: sólo junto con las campanas de estufa serie JXT-B. No se pueden sustituir con otras campanas de estufa.
  • Page 14 10” / izquierda / derecha JXA-B (Se requiere sólo en instalaciones sin sofito o de descarga horizontal directa) VENTILADOR MODELO H325B / JUEGO DE Seleccione 1 de los CAMPANA VENTILADOR EMPALME SERIE JXT-B MODELO H326-B / 2 sistemas para el...
  • Page 15: Instalación

    INSTALACIÓN INSTALACIÓN Ventilador de doble rodete modelo RM326H Ventilador de rodete sencillo modelo H325B DESCARGA VERTICAL DESCARGA VERTICAL CORDÓN ELÉCTRICO DE LA PLACA DE EMPALME PLACA DE EMPALME CORDÓN ELÉCTRICO DE LA PLACA DE EMPALME (Ubique al lado (Ubique al lado derecho de la campana)
  • Page 16: Piezas De Repuesto

    PIEZAS DE REPUESTO Modelo H325B Ventilador de rodete sencillo y juego de empalme CLAVE NÚMERO N.º DE PIEZA DESCRIPCIÓN CANT. 97010792 Conjunto del regulador de tiro 99170245 Tornillo, #8-18 X 3/8 * 97014276 Estructura soldada de la placa de empalme...
  • Page 17 PIEZAS DE REPUESTO Modelo H326B Ventilador de rodete doble y juego de empalme CLAVE NÚMERO N.º DE PIEZA DESCRIPCIÓN CANT. 97014160 Estructura soldada de la placa de empalme 99100387 Espuma de polietileno 99380605 Tuerca de cañón 99150471 Tornillo, #10-32 x ½ cabeza de arandela hexagonal * 98003370 Cubierta de la caja de salida...
  • Page 18 Felicitaciones por la compra de un electrodoméstico Jenn-Air. Deseamos expresarle nuestra confianza en el producto notificándole nuestra garantía. Todos los electrodomésticos Jenn-Air tienen como mínimo una garantía completa durante el primer año en el caso de las piezas y la mano de obra, más una garantía limitada durante el segundo año sólo en el caso de las piezas. Las garantías comienzan en la fecha de la compra.
  • Page 20 99043205A...

This manual is also suitable for:

H326b

Table of Contents