Bosch WFT2806GB Instruction Manual And Installation Instructions page 30

Rectifying minor malfunctions yourself
Foam comes out of the soap
dispenser
Foam is visible after last
rinse
Motor noise
Pump noise
Vibrations when washing
and spinning
The laundry has not been
spun
Extended programme time
Porthole cannot be opened.
The "Anti-Crease" light is
on.
Porthole cannot be opened.
The "End" light is on
Porthole cannot be opened.
The "End" light is flashing
The dryer does not function
30
Set the programme selector to the Off position to switch
machine off for approx. 5-10 minutes. Put a dessert spoon
of fabric conditioner mixed with 1/2 litre water into the soap
dispenser. Adjust detergent dosage for next wash.
Machine is attached to a domestic water softening unit.
Reconnect cold water inlet hose to direct cold water mains
supply.
Certain detergents tend to produce more foam. This has no
influence on the rinsing result.
No malfunction! Operating noises can occur in the starting
phase of the drive motor.
No malfunction! The noises when the pump starts and
sucks dry" are normal.
- Transit bolts were not removed. Follow notes in installation
instructions!
- Feet of machine were not secured when machine was
installed. Realign machine using spirit level, secure feet of
machine according to installation instructions.
Large items of laundry have bunched and are not evenly
distributed in the drum. The high speed final spin is stopped
automatically. Always mix larger and smaller items of laun
dry.
- Due to excessive foam the foam recognition system has
activated an additional rinse and an additional spin, to
improve the rinsing result.
- If there is a serious imbalance during spin, the programme
may be extended due to repeated redistribution of laun
dry. Remedy: wash large and small items together to
improve balance.
Programme is currently in Anti-crease phase:
Press the Start" button once.
After approx. 1 minute the "End" control light extinguishes.
The porthole can be opened.
- "Rinse Hold" selected (see page 21).
- Too much foam in the machine. Solution: Wait until the
foam disappears, select programme 9 (Pumping out).
The programme has ended, the porthole is still locked
The porthole can be opened:
- when the "End" light is off.
- after switching off (wait approx. 2 minutes).
- No drying programme has been selected.
- No drying programme or too short a drying programme
was selected.
- Water tap was not opened.
- Suds pump is blocked.