Epson Stylus C67 Service Manual page 42

EPSON Stylus C67/C68/D68
START
"Panel Board"
4.3.2.2 (p. 54)
"Holder Shaft Unit"4.3.3.2
"Front Frame"
(p. 56)
4.3.3.7 (p. 62)
4.3.3.2 (p. 56)
"Spool Gear 36.8/Extension
"CR Encoder Scale"
Spring 0.143/Clutch"
4.3.3.8 (p. 63)
4.3.3.3 (p. 58)
"PE Sensor Board/PE
"CR Cable Head
Detection Lever/Idle
Cover"
Roller"
4.3.3.9 (p. 64)
4.3.3.4 (p. 59)
"CR Unit"
4.3.3.10 (p. 64)
"Printhead Assy."
4.3.3.11 (p. 67)
DISASSEMBLY/ASSEMBLY
"CR Encoder Sensor
"CSIC Board"
Board"
4.3.3.12 (p. 68)
4.3.3.12 (p. 68)
Figure 4-2. Disassembling Procedure (2)
Disassembly Procedures
* Procedure in the broken-line is NOT the
shortest removing procedure, but the
passing point for the next removing
procedure.
"PS Board"
4.3.2.3 (p. 55)
"Stacker Assy."
4.3.1.2 (p. 44)
"Paper Guide, Front
Assy."
4.3.3.16 (p. 72)
"Housing, Lower Assy."
4.3.1.5 (p. 47)
"Waste Ink Pad" "PF Motor"
4.3.3.18 (p. 75)
4.3.1.6 (p. 51)
Revision A
"Holder Shaft Unit"
4.3.3.2 (p. 56)
"Pump Unit/Cap Unit"
4.3.3.17 (p. 73)
42