Panel Buttons; Standby Mode Energy Savings; Watching Broadcast Tv Channels - TCL 55US5800 User Manual

Panel buttons

The controls on the TV enable you to perform simple functions, but are not a substitute for
the remote control. The joystick-type control on the back of your TV near the lower right
side provides the following functions:
Press in to toggle between power ON and Standby.
•
Press up or down to increase/decrease the volume.
•
Press left or right to switch inputs.
•

Standby mode energy savings

When you turn off your TV, it may remain in a higher power mode for a few minutes, after which it goes
into a very low power standby mode. If you turn on the TV again before it has entered the very low
power mode, it turns on immediately. After the TV goes into the lower power standby mode, it takes a
bit longer to start up.

Watching broadcast TV channels

To watch broadcast TV, select the Antenna TV tile in the Home screen. Your TV remembers the last
channel you watched and starts with that channel playing.
Tip: You also can use the buttons on the TV panel to select Antenna TV, as explained in "Panel
buttons" on page 33.
Changing channels
To change channels, you can do any of the following:
Press the UP arrow to change to the next higher channel.
•
Press the DOWN arrow to change to the next lower channel.
•
Press the LEFT arrow to display the channel list, and then press the UP and DOWN arrows to
•
move the highlight through the list one channel at a time. Or press REWIND and FAST
FORWARD to move the highlight through the list one page at a time. When you've highlighted
Page 33