Advertisement
Testing the PESWIPS
Note: For Sony head units, please refer to the note below.
Test each Heater function of the steering wheel controls. The
TEMP and FAN should work properly. When testing the audio
controls, the left LED on the PESWIPS will fl ash indicating it
is sending a command. If any function does not work, repeat
the pro gram ming in struc tions (starting from Step 11) or refer to
Troubleshooting Guide.
Sony Head Units only!: If the Volume and Track/
Seek settings are reversed, you need to program the head
unit to reverse the input. Please refer to the radio's Owners
Manual to change this feature for the wired remote.
6
VOL
TEMP
Programming the PESWIPS to Work With the Vehicle
Step 5.
Refer to The Vehicle Appication Guide. Note the INTERFACE Version Number next to the selected vehicle. Fill in the information
below for quick reference.
Version Number:
____________
(Write Version Number here)
Step 6.
IGN
Press and hold programming/
ACC
mode button on PESWIPS. Turn
STRT
OFF
the vehicle ignition to the ON
position.
Step 7.
Release the programming/
mode button.
Step 8.
Press and release the program-
ming/mode button the same
number of times as the desired
version number.
Step 9.
After 3 seconds, the
LED will fl ash the same
amount of times of set
version number.
11-29-05
The LED on the
PESWIPS will light.
The LED will turn off,
indicating memory is
cleared.
The LED will fl ash
each time the button is
pressed and released.
Step 10.
IGN
Turn vehicle ignition
ACC
to OFF position.
STRT
OFF
Vehicle programming
sequence is complete.
3
Advertisement
