White Outdoor LT 542H Operator's Manual page 36

B. Engines with Recoil Starters
If you have an electric starter see "A. Engines with Electric
Starters" instructions on page 6. Only one of the following
two sections will apply to your engine. See Table 4.
Table 4. Engine Sections with Recoil Starters
If your engine has:
Combined Speed and Choke Controls
Independent Speed and Choke Controls
I. Combined Speed and Choke Control
1. To avoid carbon monoxide poisoning, be sure engine is
outdoors in a well-ventilated area.
2. Move combined control to "CHOKE" or "START" posi-
tion, if present (see equipment manufacturer's instruc-
tions). See Figures 13 and 14.
If restarting a warm engine after a short shutdown, move
combined Control to "FAST" instead of "CHOKE" or
"START" position. See Figures 13 and 14.
When pulling starter rope, the rope
WARNING
!
can unexpectedly jerk back toward
engine causing serious injury. To avoid this risk, carefully
follow these instructions:
3. Grasp starter cord handle. See Figure 15.
a. Pull rope out slowly until you feel drag.
b. Without allowing the rope to retract, continue
pulling rope with one rapid full arm stroke.
c. Return rope slowly to original position.
Following the instructions listed in the steps above avoids
potential damage to the recoil mechanism.
If engine fails after 3 pulls repeat steps 2 thru 3.
4. When engine starts:
d. Move combined control to "FAST" position.
e. Next, move combined control to desired speed in
"RUN" range. See Figure 13. See Figure 14.
If engine starts, but falters when combined control is moved
to "FAST" position:
a. Momentarily move combined control back to
"CHOKE" position.
Page 8
Go to:
Section B.I
Section B.II
NOTE
NOTES
NOTES
Four-Cycle Engine • Vertical Crankshaft • Air-Cooled
Figure 13. Combined Speed and Choke Control
STOP
STOP SLOW
Figure 14. Typical Engine Symbols
Figure 15. Recoil Starter
b. Next, move combined control to "FAST" position.
c. Finally, move combined control to desired speed in
"RUN" range.
If engine dies after combined control is moved to "FAST"
position, repeat steps 2 thru 4 to restart engine.
If engine fires but does not continue to run, move combined
control lever to "FAST" position and pull the starter rope.
5. If engine fails to start after 3 attempts with combined
control in the "FAST" position, move combined control
to "FULL CHOKE" position and pull the starter rope
again.
6. If engine does not start after following steps 1 thru 5,
contact your Authorized Tecumseh Servicing Dealer.
DO NOT attempt to start or troubleshoot this engine in
any other way.
RUN FAST CHOKE
181-887-14