Quick Start; Taking Still Pictures - Pentax Optio M30 Operating Manual

2
The standard procedure for taking still pictures is described below. The
flash fires automatically depending on the light conditions.
1
Press the power switch.
The camera turns on and is ready to take
still pictures. In this manual, this is called
Still Picture Capture Mode.
2
Confirm the subject and shooting
information on the LCD monitor.
The focus frame in the middle of the LCD
monitor indicates the zone of automatic
focusing.
You can change the captured area by pressing the Zoom/w/x button
to the left or right.
x : enlarges the subject
w : widens the area that is captured by the camera
3
Press the shutter release button halfway.
The focus frame on the LCD monitor turns green if the subject is in focus.
4
Press the shutter release button fully.
The picture is taken.
The image appears on the LCD monitor for one second (Instant Review)
and is saved to the SD Memory Card or built-in memory. (p.25)
38

Quick Start

Taking Still Pictures

Power switch
Shutter release button
Zoom/w/x button
03/03/2007 03/03/2007
14:25 14:25 14:25
Focus frame
38 38 38