Connecting Enervista 650 Setup Withw650 - GE Multilin W650 Instruction Manual

1.3 ENERVISTA 650 SETUP SOFTWARE
1
This section is intended as a quick start guide to using the EnerVista 650 Setup software. Please refer to section 4.1 in this
manual for more information about the EnerVista 650 Setup software interface.
a) CONFIGURING AN ETHERNET CONNECTION
Before starting, verify that the Ethernet network cable is properly connected to the Ethernet port on the back of the relay.
1. Install and start the latest version of the EnerVista 650 Setup software (available from the GE EnerVista CD or online
from http://www.GEindustrial.com/multilin
2. Go to "Communication>Computer" and enter the following data refering to communications:
3. Select Control Type as MODBUS TCP/IP from the drop-down list. This option will display a number of interface
parameters that must be entered for proper Ethernet communications.
4. Enter the relay IP address (from "Setpoint>Product Setup >Communication Settings>Network>IP ADDRESS") in
the IP Address field in MODBUS TCP/IP SETUP.
5. Enter the relay ModBus address (from "Setpoint>Product Setup >Communication Settings>ModBus
Protocol>ModBus Address COM1/COM2 setting") in the Unit Identifier (Slave Address) field.
6. Enter the ModBus port address
Protocol>ModBus Port Number" setting) in the ModBus Port field.
7.The Device has now been configured for Ethernet communications. Proceed to press the ON button to begin
communicating.
b) CONFIGURING AN RS232 CONNECTION
Before starting, verify that the RS232 serial cable is properly connected to the RS232 port on the front panel of the relay.
1. Install and start the latest version of the EnerVista 650 Setup software (available from the GE EnerVista CD or online
from http://www.GEindustrial.com/multilin
2. Go to "Communication>Computer" and enter the following data referred to communications:
3. Select Control Type as No Control Type from the drop-down list. This option will display a number of interface
parameters that must be entered for proper serial communications.
4. Enter the relay Slave Address ("Setpoint>Product Setup >Communication Settings>ModBus Protocol" menu) in the
Slave Address field.
5. Enter the physical communications parameters (Baudrate and parity settings) from
>Communication Settings>Serial Ports" menu, in their respective fields.
6.The Device has now been configured for RS232 communications. Proceed to press the ON button to begin
communicating.
1-16

1.3.3 CONNECTING ENERVISTA 650 SETUP WITHW650

(see previous section for installation instructions).
(from "Setpoint>Product Setup >Communication Settings>ModBus
(see previous section for installation instructions).
W650 Wind Generator Protection System
1 GETTING STARTED
"Setpoint>Product Setup
GEK-113032A