LG 50PX4DR Service Manual page 17

[ [ RS-232C Command
RS-232C Command
[CMD ID DATA]
R Gain ja 00 XX
G Gain jb 00 XX
B Gain jc 00 XX
R Cut lj 00 XX
G Cut lk 00 XX
B Cut ll 00 XX
12-3. Adjustment of White Balance
Operate the Zero-calibration of the CA-100, then attach
O
sensor to PDP module surface when you adjust.
Manual adjustment is also possible by the following sequence.
O
(1) Enter 'Ez - Adjust' by pressing ADJ KEY on the Service
Remote Control.
(2) Select "8. WHITE PATTERN" using CH +/- Key and HEAT
RUN at least 30 minutes by pressing the ENTER Key.
(3) Receive the Window pattern signal from Digital Pattern
Generator. (AV Input: connect the 'HDMI')
(4) After attaching sensor to center of screen, select '4. White-
Balance' of 'Ez - Adjust' by pressing the ADJ KEY on the
Service R/C. Then enter adjustment mode by pressing the
Right KEY (G) .
(5) Adjust the Hight Light using R Gain/B Gain/B Gain and
adjust the Low Light using R Cut/G Cut/B Cut.
(6) Adjust using Volume +/- KEY.
[TU-50PY22]
(G-Gain: 127 R-Cut: 63 Fix.)
High Level: 150gray
Low Level: 60gray
High X; 0.285±0.003 Y; 0.285±0.002
Low X; 0.285±0.004 Y; 0.285±0.004
Color temperature: 9,800°K±500°K
[TU-60PY22]
(G-Gain: 127 R-Cut: 63 Fix.)
High Level: 150gray
Low Level: 60gray
High X; 0.285±0.003 Y; 0.285±0.002
Low X; 0.285±0.004 Y; 0.285±0.004
Color temperature: 9,800°K±500°K
ADJUSTMENT INSTRUCTIONS
(Automatic Adjustment)
CENTER
MIN (DEFAULT)
50" 60"
00
00 7F 7F
00
00 3F 3F
00
00
MAX
ff
ff
ff
7f
7f
7f
- 17 -