SAFETY INSTRUCTIONS UNPACKING Thank you for choosing our LEDSPOT 200. For your own safety, please read this CAUTION manual before installing the device. This manual covers the important information on Becareful with your operations.With a dangerous voltage you cansuffer a installation and applications.
Specifications FEATURES & SPECIFICATIONS Input Voltage: AC90-260V 50/60Hz LED Quantities: 1*150W white LED Features Control Signal: DMX512, master-slave and sound activated or auto operation • High power 150W white LED Control Channel: 16/14/14 DMX Channels USITT DMX-512 • 50,000 hours lifespan and low power consumption Power Consumption: •...
properly when installing the fixture. PHOTOMETRIC DATA · Make sure the lens are in good condition. It’s recommended to replace the units if there are any damages or severe scratch. Photometric Beam Angle Data 15°Beam Angle LUX × 0.0929=FC · Make sure the fixture is operated by qualified personnel who knows the fixture 1147 / 12350 277 / 2985 123 / 1322...
main power cord to the appropriate wall outlet. DMX-512 CONTROL CONNECTIONS Clamp Mounting: The LEDSPOT 200 provides two unique mounting bracket assembly that integrates the bottom of the base, the included “Omega Bracket,” and Connect the provided XLR cable to the female 3-pin XLR output of your controller the safety cable rigging point in one unit (see the illustration below).
For installations where the DMX cable has to run a long Special Reset Default On/Off distance or is in an electrically noisy environment, such as 120 Ω Calibration Code(Code:088) in a discotheque, it is recommended to use a DMX PAN, TILT, Color Wheel, Gobo terminator.
040-049 Gobo 4 DMX CHANNELS 050-059 Gobo 5 060-069 Gobo 6 070-079 Gobo 7 Mode/Channel Function Values Description 080-099 Gobo 1 shake slow to fast 100-119 Gobo 1 Gobo 2 shake slow to fast 0-255 PAN Movement 120-139 Gobo 3 shake slow to fast Pan Fine 0-255 Fine control of Pan movement...
Dimmer 0-255 0-100% Linear dimmer MAINTENANCE AND CLEANING Focus 0-255 In(near) to out(far) 0-063 The following points have to be considered during the inspection: Prism, 064-127 3 Facet Prism Frost 128-191 Prism 2 1) All screws for installing the devices or parts of the device have to be tightly 192-255 Frost connected and must not be corroded.