System Reset Procedure; Procedure For Resetting Camera Functions - Hitachi DZ-MV580A Service Manual

Troubleshooting > System Resetting/Resetting Camera Functions

4-2-2 System reset procedure

1) Set the power switch to "POWER OFF", and
then disconnect the battery or AC adapter/
charger.
2) Use a fine tipped pen, etc. to hold down the
RESET button for approx. 2 seconds.

4-2-3 Procedure for resetting camera functions

1) Connect the battery or AC adapter/charger to power the DZ-MV580A/MV550A.
2) Set the power switch to "VIDEO" and place the DZ-MV580A/MV550A in the recording pause
status; loading disc is not necessary at this time. For the following steps, operate DZ-MV580A/
MV550A while viewing the LCD monitor or viewfinder.
3) Set the quick mode switch to "OFF".
4) Press the MENU button to display the camera setting menu screen.
5) Use the joystick to choose "Initial Setup", and then press the center of joystick.
6) Use the joystick to choose "Reset", and then press the center of joystick: The screen for verifying
reset will appear.
7) Use the joystick to choose "YES", and then press the center of joystick: Reset will be executed.
8) After reset, press the MENU button to close the camera setting menu.
4 - 4
RESET
Fig. 4-2-1