Operating Netcommand-Controlled Devices - Mitsubishi Electric 738 Series Owner's Manual

NetCommand Setup, continued
Adding or Removing Device Keys from
NetCommand Control
After performing initial setup, you can add or remove
individual keys under NetCommand control.
1.
Switch the TV to the device. Press
the device's icon, and press ENTER.
2.
Inputs menu and highlight the Learn icon.
Open the
3.
Learn screen displays:
When the
• To add keys:
under "Initial NetCommand Setup" on the
opposite page.
• To delete keys:
you wish to delete and press CANCEL on the
TV's remote control. Clears the check mark.
Special Operation Methods
Key Name in
Special Operation Description and Setup
Learning Screen
Power On Manual Power On/Off
Use for devices that have only one POWER key.
Power On Automatic Power On/Off
This feature is only for devices that have separate
Power Off
POWER ON and POWER OFF keys on their original
remote controls. If your device does not have a
separate POWER OFF key, do not use the Power
Off learning position; use only the Manual Power
ON/OFF method described above.
In the NetCommand Learn screen:
a. "Learn" the Power On command in the
b. "Learn" the Power Off command in the
Downloaded From TV-Manual.com Manuals
5. NetCommand IR Control (838 Series)
INPUT, highlight
Continue as described earlier
Highlight the name of the key
Power On learning position.
Power Off learning position.
Operating NetCommand-Controlled
Devices
Controlling Most Device Types
As an example of NetCommand control, if you are
watching your cable box and you wish to tune to the
next channel higher, press CHANNEL UP. NetCommand
then sends the "learned" channel-up control signal to
the cable box.
1.
Perform NetCommand setup for the device as
described in this chapter.
2.
When you wish to use the device, press
3.
Highlight the icon for the device.
4.
Press ENTER to switch the TV to the device.
Note: if you have set up automatic input switching for
the A/V receiver, the A/V receiver will automati-
cally switch to the correct input for the device.
5.
To operate the device using the
control, press the TV key to put the remote control
into TV mode.
6.
Point the remote control at the
and press the key for the desired function.
7.
Press the TOOLS key to access additional key func-
tions you may have "learned" for the device.
How to Use
1. Press INPUT.
2. Highlight the icon for the device to be
powered on or off.
3. With the Input Selection menu still dis-
played, press POWER to send the power
signal; you may need to press POWER twice.
Note: If you press POWER without the Input Se-
lection menu displayed, the TV will turn
off.
4. Press ENTER to switch the TV to the device.
• To Power On the Device
1. Press INPUT.
2.
Highlight the icon for the device to be
powered on or off.
3. ENTER to switch the TV to the
Press
device and NetCommand will send the
Power On command to the device.
• To Power Off the Device
When you turn the TV off, the TV sends all
learned Power Off commands to all devices.
For assistance call 1(800) 332-2119
65
INPUT.
TV's remote
TV (not the device)