Related Manuals for Vector V4.1
Summary of Contents for Vector V4.1
- Page 1 Network Printer V4.1 and above Installation & Commissioning Manual MVEC -03 Issue 3.0 July 2008...
-
Page 3: Table Of Contents
Installation (Retro-fit) …………………………….……………………………………………..…4 Replacing the paper roll ………………..……………………………………………………...….4 Powering up the printer ……………..……………………………………………………...…….5 Printer indications …………………………………………………………………...…………..5 Paper feed………………………………………………………………………………...……...5 Print options ………………………………………..…………………………………………...………5 Other Printouts …………………………………………………………………………………..6 Trouble shooting ………………………………….….……….…….……………………………..….6 Drawing S1620 Connection Diagram ..……………………...………………………….……..7 Technical Specification ………………………………………………………………...………..….8 Vector printer Installation and Commissioning Manual. -
Page 4: Introduction
INTRODUCTION The Vector printer is an add-on option for the Vector analogue addressable fire alarm system . The printer is integrated into a control panel lid and operates on a network basis. Therefore it can be used to produce print outs for any panel on the network. The Printer can be configured to record all events from a network or just from a local panel only . -
Page 5: Installation (Retro-Fit)
Once removed lift away the lid and fit the new lid in a similar manner, Terminate cables in line with the Drawing S1620 (see back of manual). Replacing the paper roll The printer requires special thermal paper which can be obtained from the suppliers. To fit the paper roll:- Vector printer Installation and Commissioning Manual. -
Page 6: Powering Up The Printer
Pressing this button will advance the paper. . Print options In the Vector control panel menu, item no 7. PRINT OPTIONS, four options are available:- 1. PRINT ALARM LOG. Prints all alarms and evacuations in the form, FIRE ADD 013 OPT ZONE 03 11:39 13/04. -
Page 7: Other Printouts
The printer will not print :- is there paper available, is the printer address correct. Are dil switch op- tions set correctly. Is panel V4.0 or above, is paper correctly installed.? (i.e. coating upwards). Comms disconnected:- Is PCB connected correctly. ‘Printer supply’ led out:- Check supply fuse Vector printer Installation and Commissioning Manual. -
Page 8: Drawing S1620 Connection Diagram
Drawing S1620 showing printer connection details Vector printer Installation and Commissioning Manual. -
Page 9: Technical Specification
90mm x 60mm x20mm pod on door front Dimensions (stand alone) 320mm high x 160mm wide x 85mm deep Weight 2.4 Kg Cabling FP200 or equivalent (maximum capacitance Cable glands must be used. 1µF, maximum inductance 1 millihenry) Vector printer Installation and Commissioning Manual.