Related Manuals for Pentair PROWLER 910
Summary of Contents for Pentair PROWLER 910
- Page 1 KREEPY KRAULY PROWLER ® ® ROBOTIC ABOVEGROUND POOL CLEANER INSTALLATION AND USER’S GUIDE IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS SAVE THESE INSTRUCTIONS...
-
Page 2: Table Of Contents
CUSTOMER SERVICE / TECHNICAL SUPPORT If you have questions about ordering Pentair Aquatic Systems replacement parts, and pool products, please use ® the following contact information: Customer Service (8 A.M. to 4:30 P.M. — Eastern Technical Support and Pacific Times) Sanford, North Carolina (8 A.M. -
Page 3: Important Warning And Safety Instructions
Can trap and tear hair or body parts. Hose can trip or finish or the vinyl liner, Pentair Aquatic Systems disclaims any liability for entangle swimmers which could result in drowning. - Page 4 These are all factors which can contribute to liner failure. The existence of any of these type of conditions in your pool is not caused by the use or operation of the Prowler 910. The manufacturer disclaims any liability for repairs or replacement to any of these structures or components of the customer’s pool.
-
Page 5: Initial Setup And Operation
INITIAL SETUP AND OPERATION Overview Prowler 910 Robotic Pool Cleaners are designed to scrub, vacuum, and filter your aboveground pool. The Prowler ® cleaner’s top loading basket filtration design allows for quick removal of the filter basket and easier cleaning of the basket. - Page 6 STEP 4: STEP 6: Connect Power Supply to Power Source Start the Cleaning Cycle Connect the power supply to the electrical source/outlet. Once the cleaner is resting flat on the bottom of the pool, See Figure 4. press the On/Off button on the power supply to begin a cleaning cycle.
-
Page 7: Maintenance
MAINTENANCE Make sure the cleaner’s power supply is turned “OFF” and is disconnected from the electrical source/outlet before servicing the cleaner. Moving parts may injure hands or fingers if cleaner inadvertently powers on during servicing. Removing the Cleaner from the Pool The Prowler 910 Robotic Pool Cleaner will shut off automatically at the end of a cleaning cycle. -
Page 8: Cleaning The Impeller
Cleaning the Impeller Always disconnect power to the cleaner before servicing, disassembly, or reassembly. Failure to do so could result in death or serious injury to servicemen, pool users or others due to electrical shock. Read all servicing instructions before servicing the cleaner. Every so often debris may become trapped in the Prowler 910 Robotic Pool Cleaner’s impeller. -
Page 9: Storing The Cleaner
Storing the Cleaner Any time the cleaner will not be in use for an extended period of time, for example during the winter, follow the storage recommendations below: • Be sure to disconnect the power supply. • Always coil the cleaner’s floating cable. •... -
Page 10: Troubleshooting
TROUBLESHOOTING Problem Possible Cause Corrective Action Cable twisting or cable Obstruction in pool Remove obstruction in pool. coils up. Gets stuck on main drain cover Turn off filter and install main drain cover ring. Straighten cable and lay in sun periodically. Excess cable in the pool Remove excess cable from pool. -
Page 11: Replacement Parts
REPLACEMENT PARTS Illustrated Parts List Prowler 910 Parts List Item # Part # Description 360337 Power Supply 360338 Filter Assembly 360339 Impeller Cover 360340 Impeller 360341 Motor Unit 360342 Track 360343 Communication Cable 360344 Cable Float 360345 Active Brush 360346... -
Page 12: P/N 371869 Rev. A 5/13/16
Pentair Water Pool and Spa, Inc. Those names and brands may be the trademarks or registered trademarks of those third parties.