Select radio stations and search
Read and observe
on page 9 first.
Select radio stations from the list of available stations
The device will automatically search for available radio stations in the back-
ground, which can be selected immediately after turning on the power.
›
Press the
or
button.
There will be a change to the previous or next channel.
Select radio stations from station buttons
By pressing the respective button
the given position in the current storage group (e.g. as FM1).
Semi-automatic station search
›
Press the
or
button.
A search commences in the selected direction and stops at the next station
with sufficient signal strength.
Manual station search
›
Press the
Manual button.
›
Press the
or
button repeatedly and set the desired value of the fre-
quency range.
The value of the frequency range changes by 0.1 MHz on the FM band and 9
kHz in the AM band.
Search available stations (Scan)
›
Press the
Scan →
button.
The search is started.
This function plays all the available stations in succession for a few seconds
each.
Pressing the
button again ends the search and the current station remains
set.
10
Radio
-
it changes to the station stored under
Mode settings
Introduction
This chapter contains information on the following subjects:
Settings
TP traffic
This chapter describes the settings of the Radio mode and contains informa-
tion about the function of the traffic program (TP).
Settings
›
Press the
button repeatedly.
The following menu items are displayed in sequence.
TP - Sets the traffic news reception
■
Yes - Traffic news is being received
■
No - Traffic news is not being received
■
Scan - Browse available radio stations
■
Press - Start the scan
■
Manual - Manual selection of a radio station
■
■
Press - Start the manual selection
Arrow - Sets station selection (operation of
■
Stations - Select from the list of available stations
■
■
Pre-sets - Choice from the station buttons
TP traffic
The function allows the reception of traffic information.
Switching the traffic information station on and off manually
›
Press the
TP Yes/No button.
FM frequency range
If the radio station currently selected broadcasts traffic reports, then this will
be shown in the display. If this does not transmit any Traffic Information ,
this is then displayed.
AM frequency range
No traffic reports are broadcast in the AM frequency.
10
10
or
button)