HP 12500 SERIES Configuration Manual page 34

To configure LACP MAD:
Step
1. Enter system view.
2. Assign a domain ID to the
IRF fabric.
3. Create a Layer 2 aggregate
interface and enter
aggregate interface view.
4. Configure the aggregation
group to operate in
dynamic aggregation
mode.
5. Enable LACP MAD.
6. Return to system view.
7. Enter Ethernet interface
view or interface range
view.
Command
system-view
irf domain domain-id
interface bridge-aggregation
interface-number
link-aggregation mode dynamic
mad enable
quit
• Enter interface range view:
Approach 1:
interface range
{ interface-type
interface-number [ to
interface-type
interface-number ] } &<1-5>
Approach 2:
interface range name name
[ interface { interface-type
interface-number [ to
interface-type
interface-number ] } &<1-5> ]
• Enter Ethernet interface view:
interface interface-type
interface-number
30
Remarks
N/A
The default IRF domain ID is 0.
You can change the IRF
domain ID only in the Admin
MDC. The domain ID setting
takes effect on all MDCs.
Perform this step also on the
intermediate device.
By default, an aggregation
group operates in static
aggregation mode.
Perform this step also on the
intermediate device.
By default, LACP MAD is
disabled.
After LACP MAD is enabled,
the system instructs you to
assign an IRF domain ID. At the
prompt, enter a new domain ID
or press Enter to confirm the
domain ID you have assigned.
The IRF domain ID takes effect
on all MDCs in the IRF fabric.
N/A
To assign a range of ports to
the aggregation group, enter
interface range view.
To assign one port to the
aggregation group, enter
Ethernet interface view.