Toshiba RAV-SM562KRT-E Installation Manual page 23

10
INDOOR UNIT OPERATION WHEN CONNECTED TO MULTIPLE UNITS
Procedure
Using temp. setup
5-1
specify ITEM CODE [14]. (ITEM CODE [14]: Group address)
Using timer time
5-2
(Setup data [Header unit: 0001] [Follower unit: 0002])
SET
Push button.
5-3
In this time, the setup finishes when the display changes from flashing to lighting.
If there is other indoor unit to be changed, repeat procedure 2 to 5 to change the
setup.
When the above setup has finished, push
before change of setup, specify ITEM CODE [12], [13], [14] in order with temp.
setup
Address change check Before change: [3-3-1] → After change: [2-2-2]
6
The contents during setup operation can be returned to original by pushing
After check of the changed contents, push
TEST
pushing button, the display disappears and the status becomes the usual stop
status. (When pushing
controller is not accepted for approx. 1 minute.)
7
• If the operation from the remote controller is not accepted even 1 minute or more
passed after pushing
In this case, the automatic address must be again set up.
Therefore repeat procedure of the setup change from the Procedure 1.
/ buttons,
/ buttons, change the setup data from [0001] to [0002].
/ buttons, and then check the changed contents.
TEST
button, flashes and the operation from the remote
SETTING
TEST
button, it is considered that the address setup is incorrect.
Description
UNIT
to select the indoor unit No.
TEST
button. (Setup is determined.) When
20
Indoor unit No. before setup change
is displayed.
SET DATA SETTING TEST
UNIT No.
R.C.
SET DATA SETTING TEST
UNIT No.
R.C.
Indoor unit No. before setup change
is displayed.
SET DATA SETTING TEST
UNIT No.
R.C.
SET DATA SETTING TEST
CL
UNIT No.
button.
R.C.
SET DATA
SETTING TEST
UNIT No.
R.C.
SETTING
CODE No.
No.
CODE No.
No.
CODE No.
No.
CODE No.
No.
CODE No.
No.
EN