Advertisement
BW/BWS/VW/CW/NTW/NSW weighing indicator operation manual
battery will be charged.
If the LED is green the battery has a full
charge. If it is Red the battery is nearly discharged.
As the battery is used it may fail to hold a full charge. If the battery
life becomes unacceptable then contact your distributor.
10. USER SETTING
10.1 set backlight
Hold ZERO key 3 second, display will show "setbl ", press ZERO
key to enter backlight setting, press TARE key to change backlight mode
(BL ON: always on, BL AU: auto backlight, backlight will on when press any
key or add load on scale, BLOFF: backlight always off), press ZERO
key to sure, press G/N key to escape.
10.2 set auto power off
Hold ZERO key 3 second, display will show "setbl ", press TARE
key, display show "setoff", press ZERO key to enter auto power off
setting, press TARE key to change auto power off time (of ON: always
on, of 5: auto power off after standby 5 minutes, of 15: auto power off
after standby 15 minutes), press ZERO key to sure, press G/N key to
escape.
11. CALIBRATION
Press PRINT key during the self checking. Press M+, G/N and TARE to
enter, Press TARE until display will be show p 3 cal, then you should
press calibration switch. Press ZERO key to confirm and press TARE to
select cal, press ZERO key to confirm, Press TARE key to enter
calibration, remove all the weight from the platform. Press ZERO key to
confirm. Display will be show the calibration weight. Place the
calibration weight on the platform, When indicator get stable, press
ZERO key to confirm. Display will come to normal weighing mode.
-7-
REV: C1, March 2015
BW/BWS/VW/CW/NTW/NSW weighing indicator operation manual
1. Introduction..................................................................1
2. Key descriptions..............................................................1
3. Basic operation................................................................2
3.1 Zeroing the display..............................................................2
3.2 Taring...............................................................................2
3.3 Weighing a sample...............................................................3
4. Check-weighing....................................................................3
4.1 About checkweighing............................................................3
4.2 Set limit.............................................................................3
4.3 Set check weighing mode......................................................4
4.4 Note..................................................................................4
5 Accumulated total...................................................................4
5.1 Note.................................................................................4
5.2 Accumulate operate.............................................................4
5.3 Memory recall....................................................................5
5.4 Memory clear.....................................................................5
5.5 Automatically accumulate......................................................5
6. Parts counting....................................................................5
7. Animal scales....................................................................6
8. Keyboard lock................................................................6
9. Battery operation...........................................................6
10. User setting.................................................................7
10.1 Set backlight.....................................................................7
10.2 Set auto power off..............................................................7
11. Calibration..........................................................................7
CONTENT
Advertisement
