Aevt: Assignment Of Virtual Tie Line Data For Event Based Ccis - NEC NEAX 7400 IMX Command Manual

AEVT: Assignment of Virtual Tie Line Data for Event Based CCIS

1. General
This command is used to assign Virtual Tie Line data for Event Based CCIS.
2. Precautions
1. When the parameter VRY (Verification of Connection) is assigned as "1", if the Calling party number is
not the same as the number assigned in the parameter CALLED, connection is not established.
2. This command can be used in the software Release 2 or later.
3. Data Entry Instructions
♦
When FUNC=1 (Virtual tie line data is set for each route) and TYPE=1/2 are assigned
1=Separate Channel System
2=Separate Channel System (for Call-By-Call)
3=Common Channel System
4=Common Channel System (When NPI and
TON are assigned by the ACBC command)
ROUTE
FUNCTION
NUMBER
(RT)
1-255
1
CALLED
DID number for
outgoing call
CALLED NUMBER
Note 1:
OPR and RA parameters appear for TYPE=2.
TYPE
TRUNK
NUMBER
TYPE
(TK)
1-255
Assign CCIS signal route and
trunk number.
(CALLED)
1-24
DESTINATION
E-CCIS trunk
identification number.
DESTINATION
NUMBER
(DESTINATION)
1-4
6 DIGITS
CCIS_RT/CCIS_TK
CCIS_RT CCIS_TK
1-255 1-255
OPR
Assign Outgoing Route
Selection pattern number.
ND-70348 (E)
CALLING
DID number for incoming
call from an E-CCIS
CALLING NUMBER
(CALLING)
1-24
VRY
Verification of connection
0=Not required
1=Required
VRY OPR RA
0/1 1-4000 0-7
RA
Assign the order of
route advancing.
CHAPTER 4
Revision 3.0
AEVT
Page 618