Trim Kit Installation; Installing Trim Kit Tie Bar; Side Trim Installation (Single And Dual Installations) - Electrolux TRIMKITSS2 Installation Manual

E|ectro|ux
iNSTRUCTION SHEET
Trim Kit installation
installing Trim Kit Tie Bar
(Dual installation Only)
NOTE: Leveling may be required to line up the holes
in steps "a" and "d".
5. a. Tie units together by securing the mounting
bracket at the back of the units with a
3/8" socket. (See Figure 5).
b. Install center strip to insure the proper 3/8" gap
is maintained between units. (See Figure 6).
c. Tie units together with the common mounting
bracket at the front top with two screws in
the inner two screw holes by using a 3/8" socket,
(See Figure 7)
d. Tie units together with common mounting
bracket at the bottom front using #3 Phillips
driver. (See Figure 8)
3/8" Gap
3H
Figure 5.
3/8" Gap Between Units
3/8" Center Strip
Item 1 Dual kit
Figure 6.
Item 1H
Figure 8.
Trim Kit installation (Single Unit installation)
6. Remove outer screw from top hinge using a 3/8"
socket driver or wrench and save for later. Install
mounting bracket with one screw mounted to inside
hole using a 3/8" socket, (See Figure 9).
Screw
Figure 9.
Side Trim installation
(Single and Dual Installations)
7. a. Position Left Hand Side Trim on cabinet trim with
bottom resting on the floor.
b. Drill the 1/8" (3mm) pilot hole.
c. Run screw in all the way and then back out.
Remove side trim for later install.
(See Figure 10).
NOTE: Some cabinet substrates may require pre-drilling
holes using a 1/8" (3mm) diameter drill bit.
Figure 7.
@2011 Etectrolux Home Products, Inc. Instruction Sheet 297299700 Rev. B 02.09.11