Wiring (2) - Yamaha XT 125R 2005 Service Information

WIRING (2)

1) Gas control wire
2) Carburettor starter wire
3) Clutch wire
4) Starter motor wire
5) AIS valve hose - exhaust manifold
6) Plug wire
7) AIS valve vacuum pipe
8) Air AIS valve
9) Coil
10) Coil feeding wire
11) Fuel probe connector
12) Tank cock vacuum pipe
13) Fuel feeding pipe
14) Exhaust pipe
15) Oil tank pipe- rear brake pump
16) Rear brake switch wire
17) Rear pliers oil drive
18) Battery
19) Fuse (10A)
20) CDI control unit
21) Rear right indicator wires
22) Rear left indicator wires
23) Rear light/brake wires
24) Plate light wires
25) Ground lug
26) Battery positive wire (red)
27) Battery negative wire (black)
28) Rear brake switch
What To Do
1 -Fasten wire (4) to the motorcycle frame with three
clamps (A); bring it inside plate (B) and cable gland
(H).
2 -Insert clutch wire (3) inside cable gland (C).
3 -Fasten plug wire (6) with cable gland (D) and join
to pipe (12) with clamp (E).
4 -Fasten exhaust pipes (14) with clamp (F) and cable
gland (G).
5 -Insert pipe (5) inside cable gland (H).
WIRING (2)
26
SPEC