Chevrolet TRAX 2017 Owner's Manual page 61

60 Seats and Restraints
Safety Belt Clip on Side Trim
8. Place the outboard safety belt
in the safety belt clip (if
equipped) on the side trim of
the vehicle.
9. Repeat Steps 1 8 for the other
seatback and seat cushion,
if desired.
Raising the Seatback
Warning
If either seatback is not locked, it
could move forward in a sudden
stop or crash. That could cause
(Continued)
Warning (Continued)
injury to the person sitting there.
Always push and pull on the
seatbacks to be sure they are
locked.
Warning
A safety belt that is improperly
routed, not properly attached,
or twisted will not provide the
protection needed in a crash. The
person wearing the belt could be
seriously injured. After raising the
rear seatback, always check to be
sure that the safety belts are
properly routed and attached, and
are not twisted.
To return the rear seatback to the
normal seating position:
Safety Belt Clip on Side Trim
1. Remove the outboard safety
belt from the safety belt clip (if
equipped) on the side trim of
the vehicle.
2. Lift the seatback and push it
rearward to lock it in place.
A tab near the seatback lever
retracts when the seatback is
locked in place.
Make sure the safety belts are
not pinched by the seatback
locking mechanism.