Dodge durango 2002 Owner's Installation Manual page 8

Fig. 2-5
f. Remove both metal coolant lines and their
mounts that run across the top of the engine.
On the passenger side of the engine, remove
g.
the uppermost hose fitting that was connect-
ed to the coolant hose using a 3/4" wrench.
Using Teflon sealant, install the supplied 45
h.
deg. brass fitting so it points back and up
slightly. Thread the straight hose fitting into
this using Teflon sealant. (See Figs. 2-6,
2-7.)
Fig. 2-6
Fig. 2-7
P/N: 4809632
©2002 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
25SEP02 v1.0 Dodge Durango(4809632v1.0)
i. Attach the supplied coolant hoses being
careful to get the orientation correct. If nec-
essary, hold the original metal lines in place
to see which hose goes with what fitting.
Re-use the factory spring type clamps
removed from both ends of the original
metal lines at the splice point. (See Fig.
2-8.)
j. Detach wiring harness from the front of the
engine. (See Fig. 2-9.)
k. Remove the fan belt by rotating the tension-
er using a 15mm wrench or socket.
Remove the four bolts securing the oil filler
l.
neck using a 10mm deep socket. (See Fig.
2-10.)
2-2
Fig. 2-8
Fig. 2-9