Page 1
TerraWave Solutions ® MIMO Site Survey Battery Pack (Part # TW-SSBP-007) Instructions For Use Standard Shipping Contents of the TW-SSBP-006: 1 qty Site Survey Battery Pack (Diagram 1) 1 qty Charger (Diagram 2) 1 qty RJ-45 Red (802.3af) POE Cable (Diagram 3) 1 qty 2’...
Page 2
TerraWave Solutions ® MIMO Site Survey Battery Pack (Part # TW-SSBP-007) Instructions For Use Diagram 2: Charger Diagram 3: RJ-45 Red (802.3af) POE Cable This cable is intended for use for all access points that are 802.3af POE compliant. Version 1.0 - Page 2 www.terrawave.com...
Page 3
TerraWave Solutions ® MIMO Site Survey Battery Pack (Part # TW-SSBP-007) Instructions For Use Diagram 4: 56v power cable w/barrel connector Diagram 5: 56v power cable w/barrel connector AP1252 AP1252 This cable is intended for use with the Cisco This cable is intended for use with the Cisco AP1252.
Page 4
TerraWave Solutions ® MIMO Site Survey Battery Pack (Part # TW-SSBP-007) Instructions For Use Diagram 7: Access Point Mounting Holes on Lid of Site Survey Battery Pack Front Edge (Above switches) C1, C2, P1, S2 = 8-32 threaded S1L, P1L = 10-32 threaded...
Page 5
TerraWave Solutions will replace the unit within the first month of purchase if it is deemed necessary. Within the six month warranty period, TerraWave Solutions will repair the unit if it is determined that the problem is caused by a manufacturer defect or malfunction.
Page 6
TerraWave Solutions ® MIMO Site Survey Battery Pack (Part # TW-SSBP-007) Instructions For Use Charging Instructions: 1. The Site Survey Battery Pack must be charged before each use. It is recommended to charge the Site Survey Battery Pack immediately upon receipt and before any expected use.
Page 7
4. Make sure to use the appropriate TerraWave Solutions adapter cable for your AP. Plug the cable into the appropriate power port of the Site Survey Battery Pack and place the Switch (labeled Switch in Diagram 1) into the corresponding power setting position.