Setting Up The Refrigerator - Samsung DA68-02535A User Manual

First things fi rst! Make sure that you can easily move your refrigerator to its fi nal location by measuring
doorways (both width and height), thresholds, ceilings, stairways, etc.
The following chart details the exact height and depth.
Dimensions
[mm (inch)]
• Allow clearance to the right, left, back and top when installing. This will help reduce power
consumption and keep your energy bills lower.
• Make sure you disconnect the water supply line BEFORE removing the freezer door.
To avoid damage, refer to 'Separating the water line from the refrigerator' in the manual (page 14).

SETTING UP THE REFRIGERATOR

Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and
functions of the appliance. By completing the following steps, your Refrigerator should be fully operational.
If not, fi rst check the power supply and electricity source or try the troubleshooting section at the back of
this user's guide. If you have any further questions, contact your Samsung Electronics service center.
1. Place the Refrigerator in an appropriate location with reasonable clearance between the wall and the
Refrigerator. Refer to installation instructions in this manual.
2. Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors.
3. Set the Temperature control [Refer to 'Freezer/Fridge(Temperature adjustment)', page 23] to the coldest
temperature and wait for an hour. The Freezer will get slightly chilled and the motor will run smoothly.
4. After powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You can
store food and drinks in the Refrigerator after the temperature is suffi ciently cool.
5. Assemble the water line to the refrigerator and verify that the couplers are correctly assembled without
water leakage. (Refer to 'Installing the water dispenser line', page 19~20)
Check the accessory list below.
Hex wrench
DA68-02535A(0.0).indb 11 DA68-02535A(0.0).indb 11
MODEL
Only Cabinet
Width
With Leg Front
Only Cabinet
With Door
Depth With Handle
90 ˚ Open
135 ˚ Open
Only Cabinet
Height With Hinge
With Door
Compression fi tting
RS26TDA **
F 1,169.5 / R 1,295.5
F 1,013.5 / R 1,103.5
Compression nut Clip fi tting lock(red)
RS26TKA **
908
915.5
746.5
857.5
922.5
1,752
1,776
1,774
setting up _11
2012.10.11 11:47:49 AM 2012.10.11 11:47:49 AM