Switching Off - Black & Decker GSP401 Instruction Manual

aDjuSTInG THe anGle of
THe Tool BaSkeT
warnInG:
operation, ensure that the tool is
unplugged before performing the
following operations. Failure to do this
could result in serious personal injury.
The tool basket pivots 135 degrees and can be
locked into 10 different positions within that range.
warnInG:
extension cord to the unit, be sure the tool
and the tool basket are locked into position.
• Unlock the lever (12) and adjust the
angle of the tool basket to desired angle
as shown in figure I.
• Lock the lever so the tool basket stays
securely in place.
I
connecTInG Tool anD
Pole Power corDS
warnInG:
operation, ensure that the tool and pole
power cords are unplugged before
performing the following operations. Failure
to do this could result in serious personal injury.
warnInG:
securely latched in the tool basket before
performing the following operations. Failure
to do this could result in serious personal injury.
A power plug (21) is built into the extension
pole (7). It is designed to only plug into the
special receptacle on the tools power cord.
• Connect the tools power cord (3) to the
pole plug (21) as shown in figure j.
note:
When adapter is not in use during
pole mode, wrap the hook and loop teather
around the extension pole to prevent the
adapter from interfering with operation.
j
To prevent accidental
Before connecting the
12
To prevent accidental
ensure that the tool is
3
21
adjuSting tHe pole lengtH
warnInG:
sure that the extension coupling is
completely tightened and that the extension
pole does not move before using or
transporting the tool. Not tightening the
coupling completely could result in the tool head
unexpectedly moving, creating a hazardous
condition. Periodically check the connection to
ensure that the coupling is fully tightened.
• Rotate the pole extension coupling (13)
a quarter turn counterclockwise.
• While holding the extension coupling
slide the tool basket (11) head with one
hand away from the extension coupling.
This will reveal the extension pole..
note:
The tool can be operated at any
length of the extension pole.
• Once desired extension length is
acquired, rotate the pole extension
coupling (13) clockwise until it stops and
fully secures the extension pole in place.
HanD HelD uSe
warnInG:
aT ITS own Pace. Do noT overloaD.
aTTacHInG eXTenSIon
corD To Tool
This tool utilizes an adapter to connect to
standard extension cords.
• Connect the teathered adapter plug (22)
to the tool as shown in figure k.
• Connect extension cord to the adapter plug.
k
SwITcHInG on anD off
warnInG:
SwITcHInG on
• Push and hold the lock-off button (1) to the
right or to the left and then squeeze the
trigger switch (2) as shown in figure l.
• Release the lock-off button.
note:
Once the tool is on, the lock-off
button can be released.

SwITcHInG off

• Release the trigger switch (1).
warnInG:
the switch in the on position.
9
always check to make
leT THe Tool work
22
Blades coast after turn off.
Never attempt to lock