Check for wiring or other componentry above headliner material. Cut only where indicated. Materials/ Tools required for this installation: 1. #2 Phillips screwdriver 3. 3/32” drill bit 5. Awl or similar tool 7. Audiovox Series 640/650 Video Module INSTALLATION INSTRUCTION # 44-0026B INSTALLATION INSTRUCTIONS 50-0245x-002 SERIES 1181285 50-0245x-014 SERIES 1181286 FORD EXPLORER 2.
Page 2
MATERIALS PROVIDED FOR INSTALLATION: ITEM Description SCREW, # 8 X 3/4" MOUNTING BRACKET CONSOLE...
Page 3
I. PREPARATION OF VEHICLE INTERIOR FIGURE 1 3. Install console mounting bracket (item 2 pg 2) over O.E. bracket on roof brace. Secure rear of bracket using (2) two O.E. screws. Secure front of bracket using (2) two #8 x 3/4" screws (item 1 pg 2) See Figure 2.
Page 4
III. INSTALLATION OF CONSOLE 5. Install and route all video and audio cables, and any other added component requirements to their respective places in the vehicle. Refer to component installation instructions for wiring diagrams. The suggested routing of the video system cable is as follows: Above the headliner from video system to B-pillar.