Advertisement
Quick Links
OVERHEAD CONSOLE for use with FLIPDOWN VIDEO SYSTEM
These instructions are intended for use only by experienced professionals in the automotive
customizing business. Special tools and equipment, as well as specialized handling and care
of product during installation, may be required. Before beginning this installation, carefully read
through the following instructions. Use extreme care when cutting headliner material.
Check for wiring or other componentry above headliner material. Cut only where indicated.
Materials/ Tools required for this installation:
1. #2 Phillips screwdriver
3. 3/32" drill bit
5. Awl or similar tool
7. Audiovox Series 640/650 Video Module
INSTALLATION INSTRUCTION # 44-0026B
INSTALLATION INSTRUCTIONS
FOR
50-0245x-002 SERIES 1181285
50-0245x-014 SERIES 1181286
FORD EXPLORER
2. Powered screwdriver or drill with adapter
4. Razor knife or similar
6. 18 GA wire 4' - 6'
July 7, 1999
Printed in the U.S.A
Advertisement
Related Manuals for Audiovox 50-0245x-002 SERIES
Summary of Contents for Audiovox 50-0245x-002 SERIES
-
Page 1: Installation Instructions
Check for wiring or other componentry above headliner material. Cut only where indicated. Materials/ Tools required for this installation: 1. #2 Phillips screwdriver 3. 3/32” drill bit 5. Awl or similar tool 7. Audiovox Series 640/650 Video Module INSTALLATION INSTRUCTION # 44-0026B INSTALLATION INSTRUCTIONS 50-0245x-002 SERIES 1181285 50-0245x-014 SERIES 1181286 FORD EXPLORER 2. - Page 2 MATERIALS PROVIDED FOR INSTALLATION: ITEM Description SCREW, # 8 X 3/4" MOUNTING BRACKET CONSOLE...
- Page 3 I. PREPARATION OF VEHICLE INTERIOR FIGURE 1 3. Install console mounting bracket (item 2 pg 2) over O.E. bracket on roof brace. Secure rear of bracket using (2) two O.E. screws. Secure front of bracket using (2) two #8 x 3/4" screws (item 1 pg 2) See Figure 2.
- Page 4 III. INSTALLATION OF CONSOLE 5. Install and route all video and audio cables, and any other added component requirements to their respective places in the vehicle. Refer to component installation instructions for wiring diagrams. The suggested routing of the video system cable is as follows: Above the headliner from video system to B-pillar.