Wall Mounting - Siemens DO05705 Installation & Operating Instruction

Wall mounting

Undersink appliances DO05705, DO05755,
DO05755K, DO3170D5, DO3175D5 and
DO05705CH
Align the appliance on the wall and use the three indents
(top, left and right on the appliance) to apply markings
(A).
Connect the markings by a pattern of crossed lines with a
spirit level (B1 and B2).
Place the installation bracket on top at the point of inter-
section of the drawn lines and mark the position for the
holes (C).
Drill the holes and insert wall plugs ( D1).
Attach the installation bracket (notch at top) to the wall
using the screws (D2).
Suspend the appliance in the installation bracket ( D3).
A
16
3x 3x
B1
B2
E1
en
Exchanging appliances
When replacing an old Siemens small water heater with
this new appliance, the existing drill holes with wall plugs
can be used. Please note that the new appliance is approx.
2 cm higher.
If the new appliance is to be flush at the top like the old ap-
pliance (E1):
Attach the new installation bracket to the wall with the
notches at the top.
If the new appliance is to be flush at the bottom like the old
appliance (E2):
Turn the installation bracket around and attach to the wall
with the notches at the bottom.
C
D1
2x 2x
D3
D2
E2
180°