Spoke Wheels; Adjusting The Clutch Lever Free Play - Yamaha TW200E W 2007 Owner's Manual

Spoke wheels

To maximize the performance, durabil-
ity, and safe operation of your motorcy-
cle, note the following points regarding
the specified wheels.
G
The wheel rims should be checked
for cracks, bends or warpage, and
the spokes for looseness or dam-
age before each ride. If any dam-
age is found, have a Yamaha
dealer replace the wheel. Do not
attempt even the smallest repair to
the wheel. A deformed or cracked
wheel must be replaced.
G
The wheel should be balanced
whenever either the tire or wheel
has been changed or replaced. An
unbalanced wheel can result in
poor performance, adverse han-
dling characteristics, and a short-
ened tire life.
G
Ride at moderate speeds after
changing a tire since the tire sur-
face must first be "broken in" for it
to develop its optimal characteris-
tics.
PERIODIC MAINTENANCE AND MINOR REPAIR
EAU21940
Adjusting the clutch lever free
play
3
1. Locknut (clutch lever)
2. Adjusting bolt
3. Clutch lever free play
The clutch lever free play should mea-
sure 10.0–15.0 mm (0.39–0.59 in) as
shown. Periodically check the clutch le-
ver free play and, if necessary, adjust it
as follows.
1. Loosen the locknut at the clutch le-
ver.
2. To increase the clutch lever free
play, turn the adjusting bolt in di-
rection (a). To decrease the clutch
lever free play, turn the adjusting
EAU22041
NOTE:
If the specified clutch lever free play
could be obtained as described above,
1
(a)
tighten the locknut and skip the rest of
the procedure, otherwise proceed as
follows.
(b)
2
1. Locknut (crankcase)
2. Adjusting nut
6-16
bolt in direction (b).
3. Fully turn the adjusting bolt at the
clutch lever in direction (a) to loos-
en the clutch cable.
4. Loosen the locknut at the crank-
case.
(a)
(b)
2 1
5. To increase the clutch lever free
play, turn the adjusting nut in direc-
tion (a). To decrease the clutch le-
2
3
4
5
6
7
8
9