Wireless Controller
Figure 8: DMZ configuration
In order to configure a DMZ port, the controller configurable port must be set to
DMZ in the
2.4 Universal Plug and Play (UPnP)
Advanced > Advanced Network > UPnP
Universal Plug and Play (UPnP) is a feature that allows the controller to discovery
devices on the network that can communicate with the controller and allow for auto
configuration. If a network device is detected by UPnP, the controller can open
internal or external ports for the traffic protocol required by that network device.
Once UPnP is enabled, you can configure the controller to detect UPnP-supporting
devices on the LAN (or a configured VLAN). If disabled, the controller will not allow
for automatic device configuration.
Configure the following settings to use UPnP:
Setup > Internet Settings > Configurable Port
23
User Manual
page.