Disassembly; Disassembly Flow; Bottom Panel Sub Assy - Sony MZ-NH1 Service Manual

• This set can be disassembled in the order shown below.

3-1. DISASSEMBLY FLOW

Note 1: The process described in
Note 2: Without completing the process described in
SET

3-2. BOTTOM PANEL SUB ASSY

(Page 7)
3-3. MAIN BOARD
(Page 8)
3-6. MECHANISM DECK ASSY (MT-MZNH1-181)
(Page 9)
3-7. GEAR (SA), GEAR (SB)
(Page 10)
3-8. OP SERVICE ASSY
(Page 10)
3-9. DC SSM18D/C-NP MOTOR (SPINDLE) (M701),
DC SSM21A/C-NP MOTOR (SLED) (M702),
DC MOTOR UNIT(OVER WRITE HEAD UP/DOWN) (M703)
(Page 11)
Note: Follow the disassembly procedure in the numerical order given.
3-2. BOTTOM PANEL SUB ASSY
3 bottom panel sub assy
2 two screws
SECTION 3

DISASSEMBLY

can be performed in any order.
3-4. UPPER PANEL SUB ASSY
(Page 8)
3-5. CONTROL ORNAMENT BLOCK
(Page 9)
(M1.4) L=1.6
, the next process can not be performed.
3-10. HOLDER ASSY
(Page 11)
S895
1 two screws
(M1.4) L=1.6
knob (hold)
Note: When installing the bottom panel
sub assy, adjust the position of
switch (S895) and knob (hold).
MZ-NH1
7