Cylinder Unit Replacement - Panasonic NV-FJ600A Service Manual

1. Store TV broadcasts channels by Auto/Manual Tuning using the On Screen Display according to note which taken before
replacing IC6001, MAIN C.B.A. and/or B6001.
2. Set the Direct Rec function to OFF using On Screen Display if necessary. / (Because, Direct Rec function is set
automatically to ON after resetting IC6001.) / [Direct Rec Function] / OFF: Normally set at this position. / ON: This
settingenables Direct Rec. / AV1 Input(A1) becomes exclusive channel for Direct Rec.
3. Perform the PG SHIFTER ADJUSTMENT. / (Refer to the Electrical Adjustment Procedures.)
Note:
1. It should be performed before tuning.
2. Do not cut off the power source during reset.

2.1.2. CYLINDER UNIT REPLACEMENT

1. CYLINDER UNIT REPLACEMENT
A. Remove the mechanism unit from MAIN C.B.A./Chassis by referring"SECTION 3. Disassembly Method".
B. Remove the 3 screws (A) of the CYLINDER UNIT with a screw driver.
C. Unlock the 4 locking tabs (B) and disconnect the Cylinder fiexible card from the FPC Holder.
D. Remove the CYLINDER UNIT.
CAUTION:
Handle the Cylinder flexible card with care. When it damaged, you should replace whole Cylinder unit.
http://cxema.ru
Fig. S1
Fig. S2