Advertisement
Quick Links
SPECIFICATIONS
IRR-40P
2-channel receiver w/power amplifier
Sub-carrier frequencies
Type
Modulation
Pilot Tone Signal
Frequency Response Deviation
Audio Output
Speaker Out
Line Input
Sensor Input
Power requirement
Size
Weight
IRH-15c
2-channel handheld transmitter
Sub-carrier frequencies
Modulation
Microphone element type
Frequency Response
Battery type
Battery life
Size
Weight
IRN-10
2-channel chest-worn transmitter
Sub-carrier frequencies
Modulation
Microphone element type
Frequency response
Ext Mic input impedance
Ext Mic input jack
Ext. Mic Voltage/Current
Mic gain adjustment
Battery type
Battery life
Size
Weight
IRD-60
Dome sensor
Output
Power
Cable requirement
Size
Weight
Azden Corporation, 200 Valley Road, Suite 101, Mt. Arlington, NJ 07856
phone – 973.810.3070 • fax – 973.810.3076 • email – sales@azden.com
© 2008-2015 Azden Corporation
2.06MHz & 2.56MHz
Super heterodyne – crystal controlled
FM
32.768kHz
50-10kHz ±3dB / less than 1%
RCA Jack Mono x2
5W x4 @4 Ohms
RCA Jack (L & R)
F-connector x3
15V DC @ 2.7A (use model BC-30)
8.03" W x 9.19" D x 1.73" H (204 x 233 x 44mm)
3.3lb (1.5kg)
2.06MHz & 2.56MHz switchable
FM
Uni-directional dynamic
50-8kHz ±3dB
2-"AA" alkaline( 1.5V x 2 )
2-"AA" rechargeable Ni-MH (1.2V x 2 )
> 6 hours w/alkaline batteries
9.65" x ∼1.375" (245 x ∼35mm)
9.1oz (258g) w/alkaline batteries)
2.06MHz & 2.56MHz switchable
FM
Uni-directional electret x 2
50-9kHz ±3dB
2.2k ohms
Φ 3.5mm
3.5VDC @ 1mA (to power electret mic element)
+6dB ∼ –10dB
2-"AA" Alkaline (1.5V x 2)
2-"AA" rechargeable Ni-MH (1.2V x 2)
> 8hours w/alkaline batteries
3.15" H x 2.75" W x 1.06" D (80 x 70 x 27mm)
4.3oz (120g) -w/alkaline batteries
F Connector
powered by receiver (24V @ 15mA)
RG59 - 75 ohms coaxial
3.94" x 1.18"(100x30mm)
6.00oz (170g) w/mounting bracket
Printed in USA
User's Guide
INFRARED CLASSROOM SYSTEM
IRR-40P RECEIVER • IRN-10 MIC/TRANSMITTER
IRH-15c MIC/TRANSMITTER • IRD-60 EXTERNAL SENSOR
P1101-01
Advertisement
Related Manuals for Azden IRR-40P
Summary of Contents for Azden IRR-40P
-
Page 1: Specifications
RG59 - 75 ohms coaxial Size 3.94" x 1.18"(100x30mm) Weight 6.00oz (170g) w/mounting bracket Azden Corporation, 200 Valley Road, Suite 101, Mt. Arlington, NJ 07856 phone – 973.810.3070 • fax – 973.810.3076 • email – sales@azden.com © 2008-2015 Azden Corporation Printed in USA P1101-01... - Page 2 IRR-40P IRN-10 IRH-15c...
-
Page 3: Introduction
Thank you for selecting the Azden INFRARED system as your wireless classroom solution. We are systems that use IRR-30P and IRR-40P receivers. Operation of the IRN-20 is very similar to that confident that it will perform beyond your expectations. For over 50 years Azden Corporation has been of the IRN-10 with one main additional feature: the IRN-20 has a remote volume control which creating technologically advanced products. -
Page 4: Table Of Contents
SYMPTOM CAUSE INTRODUCTION ........................ii No POWER LED a. Receiver switch is set to OFF - change to ON IRR-40P RECEIVER ......................1 b. External 15VDC power source is not connected or is Receiver front panel ......................... malfunctioning Receiver rear panel ......................... 1 c. -
Page 5: Irr-40P Receiver
B. AUTO FADER Switch - turns the AUTO FADER ON and OFF. When ON, speaking into the cable fitted with “F” connectors) is then run from the IRD-60 to the back of the IRR-40P. The microphone (either Channel 1 or 2) will mute the sound from LINE IN 1 and/or 2. -
Page 6: Frequency Selection
OFF position. Allow a minimum of 12 hours to charge the batteries will the green LED on the front panel of the IRR-40P receiver which corresponds to the chosen (overnight). The NiMH rechargeable batteries can operate either transmitter for 6-8 hours.