Maintenance - Axminster AHDP13B User Manual

Maintenance

WARNING! DISCONNECT THE MACHINE FROM THE
MAINS SUPPLY BEFORE CONTINUING!
Cleaning
Excessive dust in the motor can cause excessive heat to
develop. Every effort should be made to prevent foreign
material from entering the motor.
When operated under conditions likely to permit
accumulations of dust, dirt or waste, a visual inspection should
be made at frequent intervals. Accumulations of dry dust can
usually be blown out successfully.
Caution: To avoid eye injury or adverse reaction to dust,
high pressure hoses should not be used especially in poorly
ventilated areas. The operator performing this cleaning
function should wear safety goggles and dust filter mask.
After cleaning apply a light coat of machine oil on the quill and
chuck.
If the machine is going to stand idle for any length of time, a
light coat of spray or machine oil over the column and table
will prevent rusting. Then place a dust sheet over the pillar drill.
Electric
WARNING! DO NOT USE THE MACHINE IF THE
POWER CABLE HAS BECOME DAMAGED
If any servicing (other than the above cleaning) becomes
necessary, the unit should be returned to Axminster Tool Centre
to be repaired by one of our qualified electricians. Contact our
customer sales department for further assisance on 03332
406406 or email as @ csaxminster.co.uk .
Call: 03332 406406
Email: cs@axminster.co.uk
WARNING! DO NOT ATTEMPED TO REPAIR IT
YOURSELF CONTACT OUR TECHNICAL SALES TEAM
FOR ASSSISTANCE!
Motor speed
The speed of the motor cannot be regulated or changed - no
adjustment is necessary.
Oil Points
20