Truck-Camper Loading; Information - Chevrolet 2014 Silverado 2500HD Owner's Manual

9-20 Driving and Operating
carry inside your vehicle. Be
sure to weigh your vehicle
before you buy and install the
new equipment.
Notice: Overloading the
vehicle may cause damage.
Repairs would not be covered
by the vehicle warranty. Do
not overload the vehicle.
Remember not to exceed the
Gross Axle Weight
Rating (GAWR) of the front or
rear axle.
Maximum
* Equipment Weight
Ladder Rack 340 kg
and Cargo (750 lbs)
Cross Toolbox 181 kg
and Cargo (400 lbs)
Side Boxes 113 kg per
and Cargo side (250 lbs
per side)
Maximum
* Equipment Weight
* The combined weight for all
rail-mounted equipment should
not exceed 454 kg (1,000 lbs).
Loading Points
A. Primary Load Points
B. Secondary Load Areas
C. Cargo Management Option
Holes
Structural members (A) and (B) are
included in the pick-up box design.
Additional accessories should use
these load points. Depending on the
accessory design, use a spacer
under the accessory at the load
points to remove gap. The holes for
the Cargo Management System (C)
are not intended for attachment of
aftermarket equipment. See
www.gmupfitter.com for additional
pick-up box load bearing structural

information.

Truck-Camper Loading

Information
A vehicle-specific Truck Camper
Loading Information label is
attached to the inside of the
vehicle's glove box. This label
indicates if a slide-in camper
can be carried, how much of a
load the vehicle can carry, and
how to correctly spread out the
load. It will help to match the
right slide in camper to the
vehicle.