Sony HCD-LX10000 Service Manual page 18

HCD-LX10000
[VACS ON/OFF]
• This mode is used to switch ON and OFF the VACS (Variable
Attenuation Control System).
Procedure:
1. Press button to turn the set ON.
?/1
2. Press x button and [ILLUMINATION] button simultaneously.
The message "VACS OFF" or "VACS ON" appears on the
fluorescent indicator tube.
[TUNER STEP CHANGE]
• The step interval of AM channels can be toggled between 9
kHz and 10 kHz.
Procedure:
1. Press button to turn the set ON.
?/1
2. Press [TUNER/BAND] button repeatedly to select the "AM".
3. Press button to turn the set OFF.
?/1
4. Press [ENTER] button and
system will turn ON automatically. The message "AM 9k
STEP" or AM 10k STEP" appears on the fluorescent indicator
tube and thus the channel step is changed.
[CD SERVICE MODE]
• This mode let you move the CD sled motor freely. Use this
mode when you want to clean the optical pick-up.
Procedure:
1. Press button to turn the set ON.
?/1
2. Select CD function.
3. Press x , [ENTER] button, and
simultaneously on the fluorescent indicator tube.
4. The CD service mode is activated. The message "SERVICE
MODE" appears on the fluorescent indicator tube.
5. With the CD in stop status, turn
to move the optical pick-up to outside track, or turn
m knob counter-clockwise to move to inside track.
M
The message "SLED OUT" or "SLED IN" appears on the
fluorescent indicator tube.
6. To turn on or off the laser, press [DIRECTION] button. The
message "LD ON" or "LD OFF" appears on the fluorescent
indicator tube.
7. To release this mode, press
18
button simultaneously. The
?/1
Z
button
OPEN/CLOSE
m M knob clockwise
button.
?/1
[AGING MODE]
This mode can be used for operation check of CD section.
• If an error occurs, the aging operation would stops and the
status is displayed.
• If there were no error occurs, the aging operation would
continues repeatedly.
Procedure:
1. Press button to turn the set ON
?/1
2. Select CD function.
3. Load three discs on the disc tray.
4. Press [PLAY MODE] button on the remote repeatedly to select
the "ALL DISCS" mode, and press the [REPEAT] button on
the remote repeatedly to select "REPEAT OFF" mode.
5. Press x button, [ENTER] button and [EX-CHANGE/DISC SKIP]
button simultaneously.
6. Aging operation is started.
7. To release from this mode, press
the power cord to turn the power OFF.
Aging mode sequence:
Start (from disc 1)
Disc chucking
TOC reading
Play first track for 2 seconds
Play last track for 2 seconds
EX-CHANGE open/close
Open the disc tray
Disc skip
Close the disk tray
Change the next disc
button or disconnect
?/1