SonicWALL ex9000 Getting Started page 34

2. Click Configure. The Network Tunnel Client Settings
page is displayed.
3. Click Edit next to Address pools.
4. On the Address Pools page, click New.
5. In the Name box, enter a label for the IP address pool to be
used to allocate addresses to the network tunnel clients.
6. There are several ways to specify an address pool. As a
good basic configuration, select Translated address pool
(Source NAT) so that the appliance will assign non-
routable IP addresses to clients and use Source NAT to
translate them to a single address. The drawback is that
applications that require reverse connections, such as
VoIP or active-mode FTP, may not function properly. See
the SonicWALL Aventail Deployment Planning Guide for
information about alternatives.
7. Click Save. The address pool appears in the Address
Pools list.
8. Select the check box next to the address pool you just
configured and click Save.
9. Click OK. You should now be back on the Configure
Community - Access Methods page.
10. Click Next to define the zone of trust for employees.
Page 32 Creating an Employee Community
End Point Control for Employees
Configure the Employees community to use the zone of trust
you configured earlier (Creating Zones of Trust
To specify the Trusted zone for 'Employees':
In the Standard zones list, select the check box next to
1.
Trusted and then click the right arrow (>>) button. It is now
in the In use list.
2. Under Zone fallback options, click Place into quarantine
zone and then select Untrusted from the drop-down list.
3. Click Next to select WorkPlace appearance settings for
employees.
WorkPlace Appearance for Employees
Configure the Employees community to use the WorkPlace
"look" you defined earlier (Customizing WorkPlace
To specify the default style and layout for 'Employees':
1. In the Style list, select Default style, and in the Layout list,
select Default layout.
2. On smaller devices, the layout for this community is
automatically changed to accommodate them; for example,
the Intranet Address box (if it is part of the layout) will be
displayed on an advanced mobile device, but not a basic
one.
3. Click Finish.
on page 26).
on page 28).