Modbus User Map; Real Time Clock - GE B30 UR Series Instruction Manual

5.2 PRODUCT SETUP
• EXCH 1 DATA ITEM 1 to 20/50: These settings specify the data items that are part of this EGD exchange. Almost any
data from the B30 memory map can be configured to be included in an EGD exchange. The settings are the starting
Modbus register address for the data item in decimal format. Refer to Appendix B for the complete Modbus memory
map. Note that the Modbus memory map displays shows addresses in hexadecimal format. as such, it will be neces-
sary to convert these values to decimal format before entering them as values for these setpoints.
To select a data item to be part of an exchange, it is only necessary to choose the starting Modbus address of the item.
That is, for items occupying more than one Modbus register (for example, 32 bit integers and floating point values),
only the first Modbus address is required. The EGD exchange configured with these settings contains the data items
up to the first setting that contains a Modbus address with no data, or 0. That is, if the first three settings contain valid
Modbus addresses and the fourth is 0, the produced EGD exchange will contain three data items.

PATH: SETTINGS PRODUCT SETUP
 MODBUS USER MAP

5
The Modbus user map provides read-only access for up to 256 registers. To obtain a memory map value, enter the desired
address in the
ADDRESS
value of "0" in subsequent register
by "1". An address value of "0" in the initial register means "none" and values of "0" display for all registers. Different
values can be entered as required in any of the register positions.
ADDRESS
a) MAIN MENU

PATH: SETTINGS PRODUCT SETUP
 REAL TIME
 CLOCK
5-58


MODBUS USER MAP

ADDRESS
VALUE:
ADDRESS
MESSAGE
VALUE:
ADDRESS
MESSAGE
VALUE:
ADDRESS 256:
MESSAGE
VALUE:
line (converted from hex to decimal format). The corresponding value displays in the
lines automatically returns values for the previous
ADDRESS


REAL TIME CLOCK

SYNCRONIZING SOURCE:
None
REAL TIME CLOCK
MESSAGE
EVENTS: Disabled
IRIG-B SIGNAL TYPE:
MESSAGE
None
 PRECISION TIME
MESSAGE
 PROTOCOL (1588)
 SNTP PROTOCOL
MESSAGE

 LOCAL TIME
MESSAGE

B30 Bus Differential System
Range: 0 to 65535 in steps of 1
1: 0
0
Range: 0 to 65535 in steps of 1
2: 0
0
Range: 0 to 65535 in steps of 1
3: 0
0
↓
Range: 0 to 65535 in steps of 1
0
0
Range: None, PP/IRIG-B/PTP/SNTP, IRIG-B/PP/PTP/
SNTP, PP/PTP/IRIG-B/SNTP
Range: Enabled, Disabled
Range: None, DC Shift, Amplitude Modulated
See below
See below
See below
5 SETTINGS
5.2.5 MODBUS USER MAP
line. A
VALUE
lines incremented
ADDRESS
5.2.6 REAL TIME CLOCK
GE Multilin