Table of Contents
Advertisement
If a problem should develop while operating the CD player, an error code (ER-1, ER-2, ER-3, etc.) may appear on the display panel.
This can indicate a number of problems with the unit, including a mechanical error or an error in the microprocessor control of the
player. If an error code should appear, try ejecting and re-loading the disc into the player. While the disc is out of the unit, make sure
it is clean, undamaged, and loaded correctly (label surface up). You may also try activating the RESET button
will also erase the time and pre-set memories.
If the suggested measures do not solve the problem, contact an approved warranty station near you for further assistance.
If a problem should develop while operating the CD changer, the following error codes may appear on the display panel.
ER-1: Indicates that there is no magazine loaded in the CD changer.
ER-2: Indicates a problem with the magazine eject function.
ER-3: Indicates an error in the disc loading function.
ER-4: Indicates an error in the disc un-loading function.
ER-5: Indicates an error in the magazine position.
ER-6: Indicates an error in the laser pick-up position.
ER-7: Indicates an error in the laser focus on the disc.
In any of the above situations, try ejecting the CD magazine from the changer and make sure the discs are clean, undamaged, and
loaded correctly (refer to the Owner's Manual of the CD changer). Re-load the magazine and check for proper operation. You may
also try activating the RESET button
If the suggested measures do not solve the problem, contact an approved warranty station near you for further assistance.
CD PL
CD PL A A A A A YER ERR
CD PL
CD PL
CD PL
YER ERR
YER ERR
YER ERR
YER ERROR CODES
CD CHANGER ERROR CODES
CD CHANGER ERROR CODES
CD CHANGER ERROR CODES
CD CHANGER ERROR CODES
CD CHANGER ERROR CODES
dn
on the unit, but this will also erase the time and pre-set memories.
-13-
OR CODES
OR CODES
OR CODES
OR CODES
dn
on the unit, but this
128-6862A
13 of 16
Advertisement
Table of Contents
