Table of Contents
Advertisement
Commissioning
5.1
Safety notes for commissioning
You must only use the 6 V power adapter provided with the device for supplying power to
the RS232 modem.
Connect the modem only to the prescribed SITRANS TH100/TH200/TR200/TF200/TF with
TH200 transmitter. Only use the connecting cable provided with the modem for connecting
the modem to the PC.
Do not exceed the permitted ambient conditions
Do not expose the modem to moisture or direct sunlight. Its use is restricted to laboratory
conditions.
Ensure intrinsic safety of SITRANS TH100/TH200/TR200/TF200/TF with TH200
temperature transmitters
If the red LED on the SIPROM T modem is lit, you must check that the modem is
functioning correctly and the SITRANS TH100/TH200/TR200/TF200/TF with TH200
temperature transmitter can no longer be used in hazardous areas.
Note
Parameterization of the SITRANS TH100/TH200/TR200/TF200/TF with TH200 transmitters
may only be carried out using the SIPROM T parameterization software.
Note
The SIPROM T parameter assignment software must be installed on your PC before you
connect the USB modem to the USB port of your PC for the first time.
Note
Disconnecting the modem
Do not disconnect the transmitter from the modem during parameter assignment. After
completing the parameter assignment process, wait for two seconds before disconnecting
the transmitter. Non-observance may damage the device.
Modem and SIPROM T for SITRANS TH100/TH200/TR200/TF200/TF with TH200
Operating Instructions, 06/2014, A5E00468983-04
WARNING
WARNING
WARNING
5
33
Advertisement
Table of Contents
