Operating Instructions - Audiovox Prestige P-975 Owner's Manual

OPERATING INSTRUCTIONS

3
4,5,6,7,8
ON-OFF POWER BUTTON ( PWR )
Press this button to turn the unit on or off. When the button is pressed,
the front panel opens to reveal the radio's front panel controls.
FRONT PANEL CONTROL
Press this button to lower the motorized front panel to expose the
CD player disc slot. Pressing the button again raises the motorized
front panel and reveals the radios front panel controls.
AUDIO CONTROL ( /
To increase the volume level, press the
increase and the level will be shown on the display panel from a
minimum of VOL 00 to a maximum of VOL 39. To decrease the
volume level, press the button. The display will automatically
return to the normal indication 5 seconds after the last volume
adjustment or when another function is activated. These control
buttons are also used in conjunction with the Select (SEL) button
15
16
30
29
DISC RND DISC RND
RPT RPT
SCAN SCAN
LOC TOP
1
SEL T/F LOUD ILL
P.EQ MODE
22
21
28 12
35
17
9
27
31
) BUTTONS
button. The volume will
18
(BEHIND PANEL) TOP OF FRONT PANEL
TRACK TRACK
CH CH
EQ
ROCK ROCK
LOC LOC
ST CLAS CLAS
POP POP
LOUD LOUD
Sub. W Sub. W
RPT RND
SCN D.DN D.UP
2 3 4 5 6
AS/PS BAND
10
24 25
23
13
32
36 37
14
to adjust the bass, treble, balance and fader levels as described in
, , and
.
PUSH SELECT CONTROL BUTTON (SEL)
This button is used to select the audio function (bass, treble, bal-
ance, fade or volume) whose setting is adjusted using the AUDIO
CONTROL buttons
unit for bass adjustment (BAS will appear on the display panel)
and an audible beep will occur. Pressing the button additional
times will select treble adjustment (TRE on the display), balance
(BAL), fader (FAD), or volume (VOL) each accompanied by a beep
tone. The display will automatically return to the normal indication
5 seconds after the last adjustment or when another function is
activated.
NOTE: Bass and Treble cannot be adjusted while Equalizer
function is in ROCK, CLAS or POP mode.
-3-
26
1
2
TUNE
SKIP
TRACK
11, 19, 20,33,34
. Pressing the SEL button once will set the