Table of Contents
Advertisement
Fly
Automatic transmission
Transmission cover
- Loosen the 15 screws and remove the transmis-
sion cover with the aid of a mallet.
N.B.
THE CRANKCASE IS SLIGHTLY BLOCKED BY THE TIGHT
FIT BETWEEN THE SHAFT OF THE DRIVEN HALF-PULLEY
AND THE BEARING HOUSED ON THE CRANKCASE.
Kickstart
- Remove the seeger ring located on the exterior
of the crankshaft.
- Dismantle the dog gear from its seat, slackening
the tension that the toothed sector applies to it by
means of the spring; to do this, it is necessary to
rotate the toothed sector slightly (see the figure).
CAUTION
WHILE REMOVING THE TOOTHED SECTOR, BE VERY
CAREFUL OF THE SPRING TENSION: IT COULD CONSTI-
TUTE A HAZARD FOR THE OPERATOR.
- Upon refitting, apply the recommended grease to
the bushing, to the spring and along the toothed
sector.
- Use the special tool for the charging of the spring,
as shown in the figure.
- Refit the seeger ring after checking that it is in
good condition.
Specific tooling
020261Y Starter spring fitting
Recommended products
AGIP GREASE MU3 Grease for odometer
transmission gear case
Engine
ENG - 61
Advertisement
Table of Contents
