Advertisement

Quick Links

EN
User Manual
FAVORIT34310VIO
Dishwasher

Advertisement

Table of Contents
loading

Summary of Contents for AEG FAVORIT34310VIO

  • Page 1 User Manual FAVORIT34310VIO Dishwasher...
  • Page 2: Table Of Contents

    12. TECHNICAL INFORMATION..................18 FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it.
  • Page 3: Safety Information

    ENGLISH SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference.
  • Page 4: Safety Instructions

    Put knives and cutlery with sharp points in the cutlery • basket with the points down or in a horizontal position. Do not keep the appliance door open without • supervision to prevent to fall on it. Before maintenance, deactivate the appliance and •...
  • Page 5 ENGLISH • The appliance can release hot steam if you open the door while a programme operates. • Do not put flammable products or items that are wet with flammable products in, near or on the appliance. 2.5 Service • Contact the Authorised Service Centre to repair the appliance.
  • Page 6: Product Description

    3. PRODUCT DESCRIPTION Upper spray arm Rinse aid dispenser Lower spray arm Detergent dispenser Filters Cutlery basket Rating plate Lower basket Salt container Upper basket Air vent 4. CONTROL PANEL On/off button Programme button Programme indicators Delay button Indicators...
  • Page 7: Programmes

    ENGLISH 4.1 Indicators Indicator Description Running programme indicator. It comes on when the programme starts and goes off when the programme is completed. End indicator. Salt indicator. It is always off while the programme operates. Rinse aid indicator. It is always off while the programme operates. 5.
  • Page 8: Settings

    6. SETTINGS 6.1 Programme selection However, if this does not happen, you can set the programme selection mode mode and user mode in the following way: When the appliance is in programme Press and hold the programme button selection mode it is possible to set a until the appliance is in programme programme and to enter the user mode.
  • Page 9: Before First Use

    ENGLISH than 21°dH, you can set the lowest water not possible to deactivate these acoustic softener level. It deactivates the salt refill signals. indicator. There is also an acoustic signal that If you use standard detergent or multi- sounds when the programme is tablets without salt, set the proper completed.
  • Page 10: Daily Use

    7.1 The salt container 7.2 How to fill the rinse aid dispenser CAUTION! Only use salt specifically designed for dishwashers. The salt is used to recharge the resin in the water softener and to assure good washing results in the daily use.
  • Page 11: Starting A Programme

    ENGLISH Make sure that the appliance is in 1. Adjust the water softener to the programme selection mode. lowest level. • If the salt indicator is on, fill the 2. Set the rinse aid dispenser to the salt container. lowest position. •...
  • Page 12: Hints And Tips

    Cancelling the programme 1. Press the on/off button to deactivate the appliance. Press and hold the programme button 2. Close the water tap. until the appliance is in programme If you do not deactivate the selection mode. appliance within 5 minutes Make sure that there is detergent in the all indicators goes off.
  • Page 13: Care And Cleaning

    ENGLISH 9.3 What to do if you want to • Put cutlery and small items in the cutlery basket. stop using multi-tablets • Put light items in the upper basket. Make sure that the items do not Before you start to use separately move.
  • Page 14 5. Make sure that there are no residues of food or soil in or around the edge 1. Turn the filter (B) counterclockwise of the sump. and remove it. 6. Put back in place the flat filter (A). Make sure that it is correctly positioned under the 2 guides.
  • Page 15: Troubleshooting

    ENGLISH 10.2 Cleaning the spray arms • If you regularly use short duration programmes, these can leave Do not remove the spray arms. If the deposits of grease and limescale holes in the spray arms are clogged, inside the appliance. To prevent this, remove remaining parts of soil with a thin we recommend to run long duration pointed object.
  • Page 16 Problem and alarm code Possible cause and solution The appliance does not fill with water. • Make sure that the water tap is open. • The end indicator flashes 1 time in- • Make sure that the pressure of the water sup- termittently.
  • Page 17 ENGLISH the problem occurs again, contact an Refer to "Before first use", Authorised Service Centre. "Daily use", or "Hints and For alarm codes not described in the tips" for other possible table, contact an Authorised Service causes. Centre. Once you have checked the appliance, deactivate and activate the appliance.
  • Page 18: Technical Information

    Problem Possible cause and solution There are residues of deter- • The detergent tablet got stuck in the dispenser and gent in the dispenser at the therefore was not completely washed away by water. end of the programme. • Water cannot wash away the detergent from the dis- penser.
  • Page 19 ENGLISH your local recycling facility or contact marked with the symbol with the your municipal office. household waste. Return the product to...
  • Page 20 www.aeg.com/shop...

Table of Contents