Table of Contents
Advertisement
STEP 1. FITTING THE DISHWASHER IN PLACE
6.
Adjust the front feet by turning them clockwise to
raise or counterclockwise to lower the dishwasher.
Leave enough space to adjust them later.
7.
Screw in the back foot completely by turning the
adjustment screw at the front counterclockwise.
Use a flat-bladed screwdriver or a 1/4˝ nut driver.
(Only models with front adjustable rear foot).
If the machine does not have a front adjustable
rear foot, level the remaining rear legs just as you
did the front legs.
8.
Push the dishwasher into the cabinet. At the same
time, pull the power cord, the drain hose, and the
fill hose through the appropriate cut outs.
Use caution when sliding the dishwasher into
place. The protective slides could cause dam-
age to certain types of soft flooring.
NOTE:
If installing in a metal cabinet, the hole(s) for the
drain hose and connection pipe must be fitted with
edge protectors/rubber grommets.
9.
Lift the dishwasher a little at the front and turn the
front feet to lower them.
10. Check that the height of the machine corresponds
to the height from the floor to the bottom edge of
the counter top.
8
CUSTOMER CARE CENTER 1-800-898-1879 • WWW.ASKONA.COM
1˝ (24 mm)
1˝ (24 mm)
Advertisement
Table of Contents
